GarageAce S3 Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Garagentoröffner GarageAce S3 herunter. GarageAce S3 16 Seiten.

Seite drucken
6.
Accessory installation

6.1. Photo beam installation

Photo beam is an infrared protection system. If anything interrupts the infrared beam when
the door is closing, the opener will stop working instantly and will move back to full opening
position automatically.
6.1.1. Locating photo beam
As Fig. 29: Fix photo beam bracket on the left and right wall
outside the vertical tracks with self-drilling or expanding screws.
Then, install the photo beam inside the brackets with M6×30 screws.
Notice: The two photo beam axis should be on the same line.
Make it far from the door way as possible so as to avoid the sun shining on it.
6.1.2. Wiring
Open opener cover as Fig. 30, then connect two wire
connecting terminals of photo beam shooting part and receiving
part with the two terminals in opener marked with "PHOTO".
These two signal wires can be connected optionally.
Notice: Please set photo beam as "1"or"2"in the set up manual,
or the photo beam won't work.

6.2. Wall button installation

Please refer to step 4.3.8. for programming of remote wall switch.
Wall switch must be installed where you can clearly see the
operation of the door and must be 1.3m above the ground to
prevent the children from mal-operation.
Open the opener cover as Fig. 31, then connect the two wire
connecting terminals in the back of the wall switch with the two
terminals in the opener marked with "SW-WALL".
Then fix the wall switch on the wall by screws.

6.3. Alarm installation

This opener can connect with an alarm. If the door is opened
manually when the motor is closed, the alarm will keep beeping
for 1 min. Pressing wall switch or transmitter can stop beeping.
Connect wires according to Fig.32 and refer to the alarm
manual about the detailed alarm installation and adjustment.
Notice: Please ensure the alarm switch can be pressed when
door is
closed.

6.4. Back-up battery installation

The opener can connected with a back-up battery (optional).
The battery will be kept charged by power from the motor. When
the power fails, the opener will transfer to battery power supply
automatically. The battery is DC24V maintenance-free lead acid
storage battery or two DC 12V batteries. Please refer to Fig. 33
XT4
9
Figure 29
XT4
Figure 30
XT4
Figure 31
BLACK
RED
Figure 32
XT6
Figure 33