GarageAce S6 Benutzerhandbuch - Seite 17

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Garagentoröffner GarageAce S6 herunter. GarageAce S6 20 Seiten. Sectional/tilt garage door opener

Seite drucken

1. Coding Remotes & Wall Switch

Troubleshooting Guide

Fault

Opener not working at all

LED displays "-" – opener doesn't

work

The door opens but does not close

Open and close action works in

reverse

Door auto reverses to full open

before competely closing

Remote doesn't work

Can't add new remotes

LED displays "C" – opener doesn't

work

LED displays "H" – opener doesn't

work

LED displays "H" after opener

moves door only centimeters

Loud banging noise when door

tries to operate

Cause

1. Power supply disconnected

2. Loose wiring

1. Faulty setting of the travel limit

1. Photo beam obstruction

2. Photo beam setting is turned on

but no photo beam is installed

1. The positive and negative motor

wires on the control board are

reversed

1. There was an obstruction

2. Travel limits may not be set

correctly

3. Some older doors have

unbalanced springs

1. Flat battery in the remote

2. Motor antenna is loose or not

extended

3. Nearby interference

1. Memory is full

2. New remote is from another

brand

1. Motor cord is loose

2. Control board is damaged

1. Motor is damaged

1. Magnetic position sensor has

loose wiring to the control board

2. Magnetic position sensor or

control board is damaged

1. Belt drive is too loose

Solution

1. Check the power supply

2. Carefully open the motor cover

and check all wiring is connected

and there are no loose plugs

1. Reset the travel limits (page 11)

1. Remove obstruction

2. Cancel then photo beam setting

(see page 13)

1. Unplug the power to the motor,

remove the motor cover and

reverse the positive and negative

wires

1. Remove obstruction

2. Reset the travel limits (page 11)

3. Increase the operating force

(page 12)

1. Replace the remote battery

2. Check the antenna and fully

extend

3. Get rid of interference

1. Check that the memory is full and

clear if required (see page 11)

2. Use GarageAce™ remotes only

1. Reinsert motor cord

2. Replace control board (refer

supplier)

1. Replace motor (refer supplier)

1. Turn the power off, remove the

motor cover and check the sensor

wiring

2. Replace the magnetic sensor or

control board (refer supplier)

1. Tighten belt drive

S6 Instruction Manual