CORNING PCH-96F-01U Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Netzwerk-Hardware CORNING PCH-96F-01U herunter. CORNING PCH-96F-01U 9 Seiten. Rack-mountable 1u 96-fiber housing

Seite drucken

4.8

Install Jumpers

Step 1:

Remove dust caps from the connectors and adapters into which they will be mated.

Refer to Section 5 for cleaning instructions or clean connector end-faces and

adapters per standard company practices and insert connectors into adapters.

Step 2:

Install jumpers as specified on planning diagrams. The panel can be raised to access

the adapters on the bottom row. When raising the panel, the cover must be removed

to prevent damage to the connectors on the back side of the panel. Cut the provided

hook-and-loop strap into small sections and feed the strap through the appropriate

lance at the front of the housing. Loosely secure jumpers using the straps at the front

of the housing (Figure 10).

KPA-1023

Step 3:

Provide enough jumper slack to allow the connector panel tray to slide backward and

forward without violating the minimum bend radius of the jumper.

Step 4:

Record jumper routing information on the provided identification label. The

identification panel can be removed, if desired. Accurate recordkeeping is imperative

for an organized installation.

Connector Care and Cleaning

WARNING: Isopropyl alcohol is flammable with a flashpoint at 54ºF. It can cause irritation to

eyes on contact. In case of contact, flush eyes with water for at least 15 minutes. Inhalation

of vapors irritates the respiratory tract. Exposure to high concentrations has a narcotic effect,

producing symptoms of dizziness, drowsiness, headache, staggering, unconsciousness and

possibly death.

•

Always keep dust caps on connectors and adapters when not in use.

•

Ensure dust caps are clean before reuse.

•

Use optical cleaning materials as standardized by your company.

•

Clean the connector before every mating, especially for test equipment patch cords

(jumpers).

•

A minimum level of cleaning is listed below. Local procedures may require more rigorous

cleaning methods.

Step 1:

Remove plugs from the connector adapter.

Step 2:

Wipe the connector ferrule twice with a lint-free wiping material moistened with

isopropyl alcohol. Then wipe across the end of the ferrule.

Step 3:

Repeat previous step with a dry wipe.

STANDARD RECOMMENDED PROCEDURE 003-723 | ISSUE 2 | OCTObER 2015 | PAGE 8 OF 9

Figure 10