Makita 4399DW Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 4399DW herunter. Makita 4399DW 12 Seiten. Cordless equine rasp

Installing or removing/adjustment of rasp blade and holder

CAUTION:

Always be sure that the tool i s switched off and the battery cartridge is removed before

Always be sure that a l l bolts which secure the rasp blade or holder are securely tightened

installing or removing/adjustment of the rasp blade and holder.

before use.

1. Use an 82 mm x 25 mm x

mm rasp

blade which i s available on the market.

To install the rasp blade, slide into the

holder up to the stop and tighten both

securing bolts using the hex wrench.

3. The holder

is held on the drive shaft

with the rasp blade facing upward. If

you wish to re-install the holder on the

drive shaft with the rasp blade facing

downward, proceed as follows.

i) Loosen the securing bolt using the

hex wrench and pull the holder out

of the drive shaft.

ii) Turn the holder upside down and

insert it into the drive shaft.

iii) Tighten the securing bolt using the

Rasp b l a d e - ,

Securing bolt

Hex wrench

Tighten

Drive shaft

Securing bolt

Hex wrench

hex wrench after aligning the securing bolt with the notch on the drive shaft.

In normal use the holder is used in the

flat position: for the first premolar the

holder is angled, The holder is activated

pressing

the spring loaded trigger and

moving to the position required and

then releasing the trigger.

vTr