CORNING CCH Schnellstart-Handbuch
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Kontrolleinheit CORNING CCH herunter. CORNING CCH 2 Seiten. Lc duplex shuttered adapters
Seite drucken
6.
Maintenance
The most likely cause of a problem with a module is connector end-face
contamination. Always keep clean dust caps on the module's MTP connector
adapters and the trunk's connectors when they are unmated, and clean the
connectors before each mating.
To clean LC duplex connectors
and the LC shuttered adapters on
the front of the CCH module, use
a CLEANER-PORT-LC tool as
described in its instructions.
To clean the MTP connectors and
adapters, use an MTP connector
cleaning tool (p/n 2104466-01)
as described in its instructions
(Figure 4).
Periodically check the fiber optic cable to make sure bends do not exceed the
minimum bend radius. Check the trunk for unnecessary strain. Check the trunk
cable for crimping or crushing.
Corning Cable Systems LLC • PO Box 489 • Hickory, NC 28603-0489 USA
800-743-2675 • FAX: 828-901-5973 • International + 1-828-901-5000 • www.corning.com/cablesystems
Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable
Systems' products without prior notification. MTP is a registered trademark of US Conec Ltd. All other trademarks are the
property of their respective holders. Corning Cable Systems is ISO 9001 certified.
© 2009 Corning Cable Systems LLC. All rights reserved.
STANDARD RECOMMENDED PROCEDURE 003-122 | ISSUE 1 | MAY 2009 | PAGE 4 OF 4
CLEANER-PORT-LC
2104466-01
Figure 4 - Connector cleaning tools
revision history |
Issue
Date
1
May 2009
1.
General
This document describes the installation and maintenance of the 12 and
24-fiber versions of CCH Plug & Play™ System modules equipped with LC
duplex shuttered connector adapters (Figure 1).
The shuttered LC adapters used in these modules eliminate the use of
easily misplaced individual dust caps and ensure that the adapters remain
clean when not in use.
IMPORTANT: CCH modules are factory sealed. Breaking the seal will void the
manufacturer's warranty.
STANDARD RECOMMENDED PROCEDURE 003-122 | ISSUE 1 | MAY 2009 | PAGE 1 OF 4
CCH Modules with LC Duplex
Shuttered Adapters
cat. number 003-122, Issue 1
Reason for Change
Initial Release
Figure 1 - 12 and 24-fiber CCH Modules