CORNING SCT-001-UCN Betriebsanleitung
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Werkzeuge CORNING SCT-001-UCN herunter. CORNING SCT-001-UCN 3 Seiten. Installation tool kit ucn
Seite druckenTable of Contents
1. General ................................................................ 1
2. Precautions .......................................................... 1
3. Tool Kit Contents ............................................... 1
4. Operation of Cutting Tool ................................. 2
5. Testing and Adjusting Cutting Tool .................. 3
1.
General
1.1 The following instructions describe the
recommended procedures for adjusting and
operating the End Cap Cutting Tool.
Installation Video available. Please ask Corning
Customer Service Representative for
#VK8HTELSDH (English).
1.2 This document is being reissued to make
changes in the tool kit contents.
2.
Precautions
IMPORTANT: Read and understand this
procedure completely before operating the cutting tool.
p/n 205-368
SCT-001-UCN Installation Tool Kit UCN Operating Instructions
Figure 1
WARNING: The wearing of safety gloves to
protect hands from accidental injury when using sharp
instruments is strongly recommended.
3.
Tool Kit Contents
Each carton contains the following:
Cutting Tool
Tool Handle
Cutting
Tool
Support
T-Handle
Tool
•
Cutting Tool with
Handle — is used
for cutting holes
in the end caps.
•
Spare cutting
blade — is a
replacement for
the original
blade.
•
Cutting tool
support — is used
to mount the
cutting tool to
stable object.
•
Allen Wrench - is
used for
replacing cutting
blade.
Corning Cable Systems
SRP-205-368
Issue 4, January 2003
Page 1 of 3
Allen
Wrench
Spare
Installation
Cutting
Block
Blade
Figure 2
•
T-Handle Tool — is
used to move
index slide to the
proper hole
diameter setting
and install
grounding plugs.
•
Tool case (not
shown) — is a
shock resistant
case used to carry
all of the
preceding items.
•
Installation Block —
is used to install
and remove
clamping bars.