Makita 5603R Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita 5603R herunter. Makita 5603R 12 Seiten. 165/190/235 mm
Auch für Makita 5603R: Gebrauchsanweisung (13 seiten), Handbuch (15 seiten), Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (13 seiten), Gebrauchsanweisung (16 seiten)
Seite drucken
To avoid kickback, do support
board or panel near the cut.
000154
Do not support board or
panel away from the cut.
000156
Do not use dull or damaged blades.
•
Unsharpened
produce narrow kerf causing excessive friction,
blade binding and kickback. Keep blade sharp
and clean. Gum and wood pitch hardened on
blades slows saw and increases potential for
kickback. Keep blade clean by first removing it
from tool, then cleaning it with gum and pitch
remover, hot water or kerosene. Never use
gasoline.
Blade depth and bevel adjusting locking
•
levers must be tight and secure before
making cut. If blade adjustment shifts while
cutting, it may cause binding and kickback.
Use extra caution when sawing into
•
existing walls or other blind areas. The
protruding blade may cut objects that can
cause kickback.
ALWAYS hold the tool firmly with both
•
hands. NEVER place your hand or fingers
behind the saw. If kickback occurs, the saw
could easily jump backwards over your hand,
leading to serious personal injury.
or
improperly
set
blades
000194
Never force the saw. Forcing the saw can
•
cause uneven cuts, loss of accuracy, and
possible kickback. Push the saw forward at a
speed so that the blade cuts without slowing.
10.
Check lower guard for proper closing before
each use. Do not operate the saw if lower
guard does not move freely and close instantly.
Never clamp or tie the lower guard into the
open position. If saw is accidentally dropped,
lower guard may be bent. Raise the lower guard
with the retracting handle and make sure it moves
freely and does not touch the blade or any other
part, in all angles and depths of cut.
To check lower guard, open lower guard by hand,
then release and watch guard closure. Also check
to see that retracting handle does not touch tool
housing.
Leaving
DANGEROUS and can lead to serious personal
injury.
11.
Check the operation of the lower guard spring.
If the guard and the spring are not operating
properly, they must be serviced before use.
Lower guard may operate sluggishly due to
damaged parts, gummy deposits, or a build-up of
debris.
12.
Lower guard may be retracted manually only
for special cuts such as "plunge cuts" and
"compound cuts". Raise lower guard by
retracting handle and as soon as blade enters
the material, the lower guard must be released.
For all other sawing, the lower guard should
operate automatically.
13.
Always observe that the lower guard is
covering the blade before placing saw down on
bench or floor. An unprotected, coasting blade will
cause the saw to walk backwards, cutting whatever
is in its path. Be aware of the time it takes for the
blade to stop after switch is released. Before
setting the tool down after completing a cut, be
sure that the lower guard has closed and the blade
has come to a complete stop.
6
blade
exposed
is
VERY