James SONIC D Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Ultraschall-Schmuckreiniger James SONIC D herunter. James SONIC D 8 Seiten.

Seite drucken

Setting the timer– When power is on, the timing setting figure will flash once

the

option button has been pressed. This indicates that a time setting is

required. To set the timer, press the

time (Minutes).

The ultrasonic's cleaning function will instantly start once the

pressed. The LCD display window displays "U" which represents that the ultrasonic

is working. Cleaning will stop automatically when the cleaning time (seconds)

and (minutes) has counted down to "00" on both sides. The figure will resume

the original setting automatically. This is the "memory function".

Memory Function and Pause Function

the Green Button is touched; the memory function will be activated to keep

the "MIN" figure in the memory (but not the "SEC"). When the timer stops

automatically, the memorized "MIN" figure will be remembered. It is convenient for

frequent users who repeat with same cleaning time cycle, as there is no need to

reset again and again. The Green Button is also a PAUSE function button allowing

you to pause the unit whilst the ultrasonic timer is still running, touch

to release the pause and continue the operation ( need to RESET desired memorized

setting figure again after Pause function is used).

Use of degassing function: at the normal working state, the machine will start

degassing function once the

Degassing function will stop once

displays "U".

Red Button- This is the power switch for the machine. When you have finished

using the machine, touch

to make sure that all of the displays have turned oﬀ.

Disconnect the unit from the mains supply and remove the power cable.

button to set the required cleaning

button is

(= Start/Pause)--Every time

button is pressed. Then, the LCD displays "D".

button is pressed again. Then, the LCD

SONIC MX SERIES

Timer Dial:

Sets duration of

cleaning cycle.

again

Sweep:

Creates a wave amongst the cleaning

solution. Providing enhanced

cleaning of tubular items.

Degas:

Intermittent operation of ultrasonic

power for rapid removal of entrained

air from liquids.

Pulse:

Produces intense bursts of ultrasonic

power. Use to remove stubborn

contaminants or degas solution rapidly.

Temp Dial:

Adjusts thermostat

of ultrasonic heating

element.

Power:

Adjusts the power rating of

the transducer.

Start/Stop:

Starts and stops ultrasonic cleaner.

Power On/Oﬀ:

Primes unit for adjusting cleaning time. This

is then altered using + / – buttons above.