Makita AN901 Gebrauchsanweisung - Seite 6
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita AN901 herunter. Makita AN901 12 Seiten. Construction coil nailer
Auch für Makita AN901: Gebrauchsanweisung (20 seiten), Aufschlüsselung der Teile (4 seiten)
Seite drucken
Attach the nose adapter to the contact arm. When not in
use, store the nose adapter at the rear of the tool to keep
it from being lost.
1
2
005463
Adjusting depth of nailing
To adjust the depth of nailing, turn the adjuster so that the
arrow above the adjuster will point to the number
indicated on the adjuster. The depth of nailing is the
deepest when the arrow points to the number 1. It will
become shallower as the arrow points to higher number.
The depth can be changed in approx. 1.0 mm increments
per graduation. If nails cannot be driven deep enough
even when the arrow points to the number 1, increase
the air pressure. If nails are driven too deep even when
the arrow points to the number 9, decrease the air
pressure. Generally speaking, the tool service life will be
longer when the tool is used with lower air pressure and
the adjuster set to a lower number.
1
005467
ASSEMBLY
CAUTION:
Always lock the trigger and disconnect the hose
•
before carrying out any work on the tool.
Loading nailer
Select nails suitable for your work. Depress the latch
lever and open the door and magazine cap.
1. Contact arm
2. Nose adapter
1. Adjuster
6
1
2
005464
Lift and turn the coil support plate to set it to the correct
step. When loading 90 mm long nails, use the bottom
step. When loading 65 or 75 mm long nails, use the
middle step. When loading 45 or 50 or 57 mm long nails,
use the top step. If the tool is operated with the coil
support plate set to the wrong step, poor nail feed or
malfunction of the tool may result.
1
2
005465
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the feed claw. Place the first nail in
the driver channel and the second nail in the feed claw.
The nail heads must be in the slot in the feeder body.
Place other uncoiled nails on feeder body. Close the
magazine cap and door after checking to see that the nail
coil is set properly in the magazine.
005466
Connecting air hose
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
1. Latch lever
2. Door
3. Magazine cap
3
1. Magazine scale
2. Coil support
plate
1. Slot
1
2. Feeder body
2