KitchenAid Architect Series II KDRS807SSS Handbuch installieren
Blättern Sie online oder laden Sie pdf Handbuch installieren für Ranges KitchenAid Architect Series II KDRS807SSS herunter. KitchenAid Architect Series II KDRS807SSS 1 Seiten. 30" freestanding and slide-in dual fuel range
Seite drucken
PRODUCT MODEL NUMBERS
KDRS807S
KDSS907S
Gas supply:
Provide a gas supply line of 3/4"
(1.9 cm) rigid pipe to the range location. A smaller
size pipe on longer runs may result in insufficient
gas supply. Pipe-joint compounds that resist the
action of LP gas must be used. Do not use
TEFLON
®
tape. With LP gas, piping or tubing size
can be 1/2" (1.3 cm) minimum. Usually, LP gas
suppliers determine the size and materials used in
the system. If local codes permit, a new CSA
design-certified, 4' - 5' (122 - 152.4 cm) long,
1/2" (1.3 cm) or 3/4" (1.9 cm) I.D., flexible metal
appliance connector may be used for connecting
range to the gas supply line. A 1/2" (1.3 cm) male
pipe thread is needed for connection to the female
pipe threads of the inlet to the appliance pressure
regulator. The supply line must be equipped with a
manual shutoff valve. This valve should be located
in the same room but external to the range. It
should be in a location that allows ease of opening
and closing.
Electrical:
When a 4-wire or 3-wire, single phase
120/240 volt, 60 Hz, AC only electrical supply is
available, a 50-amp maximum circuit protection is
required. When a 4-wire or 3-wire single phase
120/208 volt 60 Hz, AC only electrical supply is
available, a 40-amp maximum circuit protection is
required, fused on both sides of the line. A separate
circuit is recommended. A time-delay fuse or circuit
breaker is recommended.
SLIDE-IN COUNTERTOP PREPARATION
30"
(76.2 cm)
30 ¾"
(78.1 cm)
INSTALLATION CLEARANCES
F
e r
e
s
a t
n
d
n i
g
R
a
n
13" (33 cm) upper
cabinet depth
30" (76.2 cm) min.
opening width
18" (45.7 cm)
upper cabinet
30" (76.2 cm)
to countertop
min. opening
width
8"
5" (12.7 cm) min.
(20.3 cm)
clearance from
both sides of the
8"
range to the side
(20.3 cm)
wall or other
combustible
7" (17.8 cm)
material.
This shaded area
recommended for
installation of
1-1/2"
rigid gas pipe.
(3.8 cm)
4-1/2"
(11.4 cm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
®
30" Freestanding and Slide-In Dual Fuel Range
PRODUCT DIMENSIONS
5-3/4"
(14.6 cm)
*Range can be raised approximately 1"
(2.5 cm) by adjusting the leveling legs.
**When installed in a 24" (61 cm) base cabinet
with 25" (63.5 cm) countertop; front of oven
door protrudes 1" (2.5 cm) beyond 24"
(61 cm) base cabinet.
The cooktop sides of the slide-in range fit over the
cutout edge of your countertop.
³⁄₈"
If you have a square finish (flat) countertop and the
(1.0 cm)
opening width is 30" (76.2 cm), no countertop
preparation is required.
Formed front-edged countertops must have molded
edge shaved flat 3/8" (1.0 cm) from each front corner
of opening.
g
e
s
For minimum
clearance to top
of the cooktop,
see NOTE.
18" (45.7 cm)
upper cabinet
to countertop
Cabinet door
This shaded area
5" (12.7 cm) min.
or hinge
recommended
clearance from
should not
for installation
both sides of the
extend into
of outlet or
range to the side
the cutout.
junction box.
4-1/2"
(11.4 cm)
This shaded area
recommended for
installation of
rigid gas pipe.
Available
area for
gas and
electric
installation.
Freestanding Range
30"
(76.2 cm)
Model/serial number
27-1/4"
plate (located on the
(69.2 cm) max.
right-hand side
from handle to
oven door trim)
standoff at
back of range**
l S
d i
- e
n I
R
a
n
g
e
13" (33 cm) max.
upper cabinet depth
30" (76.2 cm) min.
opening width
3/4" (1.9 cm)
radius both corners
30" (76.2 cm)
min. opening
width
6"
(15.2 cm)
6"
wall or other
(15.2 cm)
combustible
7" (17.8 cm)
material.
1-1/2"
(3.8 cm)
4-1/2"
(11.4 cm)
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Slide-in Range
30-9/16"
(77.6 cm)
36" (91.4 cm)
cooktop trim
height with
23" (58.4 cm)
leveling legs
countertop
screwed all
notch to rear
the way in*
of countertop
41-3/4"
(106 cm)
overall height
with leveling
legs screwed
all the way in*
27-1/4"
(69.2 cm) max.
from handle to
standoff at
back of range**
*Range can be raised approximately 1"
(2.5 cm) by adjusting the leveling legs.
**When installed in a 24" (61 cm) base cabinet
with 25" (63.5 cm) countertop; front of oven
door protrudes 1-3/4" (4.4 cm) beyond
24" (61 cm) base cabinet.
Tile countertops may need trim cut back
3/8" (1.0 cm) from each front corner and/or rounded
edge flattened.
If countertop opening width is greater than
30" (76.2 cm), adjust the 3/8" (1.0 cm) dimension.
Countertop must be level. Place level on countertop,
first side to side; then front to back. If countertop is
not level, range will not be level. Range must be level
for satisfactory baking conditions.
s
NOTE:
24" (61 cm) minimum when bottom of
wood or metal cabinet is protected by
For minimum
clearance to top
not less than 1/4" (0.64 cm) flame
of the cooktop,
see NOTE.
retardant millboard covered with not
less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel,
22-15/16" (58.3 cm)
0.024" (0.6 mm) aluminum or 0.020"
opening depth
(0.5 mm) copper.
30" (76.2 cm) minimum clearance
between the top of the cooking
Cabinet door
This shaded area
or hinge
recommended
platform and the bottom of an
for installation
should not
extend into
of outlet or
unprotected wood or metal cabinet.
the cutout.
junction box.
If installing a range hood or
4-1/2"
(11.4 cm)
microwave hood combination above
the range, follow the range hood or
Available
microwave hood combination
area for
gas and
installation instructions for
electric
dimensional clearances above the
installation.
cooktop surface.
35-5/8" (90.5 cm)
height to underside
of cooktop edge
with leveling legs
screwed all
the way in*
Model/serial
number plate
(located on the
right-hand side
oven door trim)
30"
(76.2 cm)
Ref. W10154991
06-24-08