Makita BHP453Z Technische Informationen - Seite 4

Blättern Sie online oder laden Sie pdf Technische Informationen für Elektrowerkzeug Makita BHP453Z herunter. Makita BHP453Z 6 Seiten. 18v cordless hammer driver drill 13mm (1/2")

Seite drucken

epair

[3] DISASSEMBLY/ASSEMBLY

[3]-2. Gear Ass'y and DC Motor (cont.)

ASSEMBLING

Do the reverse of the disassembling steps.

The following portions of DC motor, Motor bracket and Gear ass'y have to face the same side. (Fig. 7)

* Red point mark (designated as plus terminal) on DC Motor

* None of protrusion side of Motor bracket

* protrusion of Gear ass'y

Fig. 7

protrusion of Gear ass'y

Gear ass'y

Do not face the protrusion of

Motor bracket to the protrusion

of Gear ass'y and the red

point mark on DC motor.

[3]-3. Speed Change Lever

ASSEMBLING

(1) When assembling Speed change lever ass'y, make sure that Compression springs 4 (2 pcs.) are assembled to its bottom

in advance. (Fig. 8)

(2) Fit the protrusion of Gear ass'y into Compression spring 4 in Speed change lever ass'y . (Fig. 9)

(3) After mounting, set Speed change lever ass'y to low speed mode or high speed mode. (Fig. 10)

Fig. 8

Compression

spring 4 (2 pcs.)

Speed change lever

ass'y

Fig. 10

1: Low speed mode

Speed change

lever ass'y

none of protrusion

side

Motor bracket

DC motor

Note : Be sure to Cover the center of DC motor with Cap.

Fig. 9

protrusion of Gear ass'y

2: High speed mode

Slide Speed change lever to either of

the direction designated in arrow, and hold

the position.

red point mark

on DC motor

Cap

P 4/ 6