James May Engineering Ultra Tonic Pickup Einbauanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Einbauanleitung für Zubehör für Musikinstrumente James May Engineering Ultra Tonic Pickup herunter. James May Engineering Ultra Tonic Pickup 5 Seiten.

Seite drucken

little less feedback immunity. You may prefer the sound of one of these positions if it has enough

feedback immunity for your needs.

5. Wrap it up

The pickup installation can be completed three ways, depending on preference. These correspond to the

three shorting jumper positions:

Jumper position 1. An optional switch may be connected to terminal pads 6 and 7 to allow using



the pickup with and without feedback suppression. If you want to use this option, James May

Engineering can supply a suitable switch and shielded connection wire for a modest charge. Or,

you can rig up your own. Mount the switch next to the sound hole, with enough overhang to

enable access. A dab of hot melt glue works quite well for this purpose. The pickup signal

appears on TIP with respect to SLEEVE ground.

Jumper position 2 is the most typical installation. The pickup always operates in feedback



suppression mode, and appears on TIP with respect to SLEEVE ground.

Jumper position 3. The feedback suppression pickup signal is brought out of the guitar on the



RING pin. The main pickup is wired to TIP. This way, they can be combined with an external

switch or even a mixer.

Install the balancing circuit with endpin jack in the end block of the guitar, in the usual way.

Enjoy your new pickup!