AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Handbuch für Zelt AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK herunter. AIRFRAMES ALASKA ARCTIC OVEN GREAT NUNATAK 3 Seiten.
Seite druckenTENT FLY SET UP CONTINUED
- Once the tent has been set up you will need to adjust the fly on the frame of the tent.
- Evenly pull out the fly around the tent, and line up the top of the tent reinforced corners with halo corners.
- Stake out ALL of the loops on the bottom of the fly around the perimeter.
- Make sure the fly remains centered on the square halo rings as you stake it out.
- Line up the ventilation tubes at the front and rear of the tent. Leave the tubes open at all times, especially when using any
form of heat source inside the tent.
- Now you can attach your high wind tie-outs on all of the guy-out points around the tent. We recommend using our high-wind
tie-out package for a simple and reliable guy-out solution.
- When using a stove, unzip the ceiling of the tent body, roll back and clip the flap out of the way for the stove pipe installation.
BEFORE YOU INSTALL THE TENT FLY:
- If you are planning to use a stove inside of the tent, you will need to cut out the opening for the stove pipe on the silver
square material (silica) at the peak of the tent fly. There are "guide stitches" sewn in circles on the silica square that
correspond with common stove pipe sizes (See photo below).
- Remove the stove jack cover flap by peeling it from the Velcro.
- Determine how big the stove jack opening needs to be based on the size of your stove pipe.
- Fold the silica square in half and cut out the stove jack on the inside of the guide stitches sewn into the silica material.
KNOW BEFORE YOU GO
It is highly recommended that you set up your tent BEFORE going into the field to familiarize yourself with the instructions.
This tent model was designed to be set up by one person.
Stove Jack
Final tent setup.
Spider (x2)
907.331.4480
Center Pole (x2)
@arcticoven
Ridge Pole
Halo (x2)