Gardco P15P Series Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Außenleuchte Gardco P15P Series herunter. Gardco P15P Series 8 Seiten.

Seite drucken

INSTALLATION INSTRUCTIONS

PUREFORM GEN. 2 – P15 & P20 ARM MOUNT (AR1)

REQUIRED TOOLS: 9/16" SOCKET/OPEN‐END WRENCH & #2 PHILLIPS‐HEAD SCREWDRIVER

STEP 1: ASSEMBLE BOLSTER PLATE

Attach cage nut to the bolster plate provided. Hold

bolster plate inside pole with top hole aligned with top

mounting hole in pole.

STEP 2: INSTALL TOP BOLT

Begin threading (1) 3/8"‐16 x 2" bolt, split washer

and flat washer through top mounting hole and into

nut. Do not tighten top bolt all the way, leaving ap-

prox. 1" gap for hanging luminaire.

NOTE: Use supplied square pole adapter between

luminaire and pole for square pole install. Remove

film from PSA and secure the adapter to the pole

over the mounting holes.

STEP 3: INSTALL LUMINAIRE

Loosen the retained Arm Cover screw and lower the

Arm Cover. Hang luminaire over top bolt using

key slot feature on back of arm. Ensure that the

washers remain on the inside of luminaire. Install

remaining (1x) 3/8"‐16 x 2" bolt, split washer and

flat washer through the lower mounting slot on the

arm and into the bolster plate.

Torque mounting hardware to 20 ft‐lbs.

STEP 4: MAKE WIRE CONNECTIONS

Once luminaire is installed and hardware is properly

torqued, make supply wiring connections according

to the appropriate wiring diagram.

* 0-10V AND OVERRIDE WIRES OPTIONAL

* WIRE NUTS SUPPLIED BY OTHERS

STEP 5: REINSTALL ARM COVER

Move the Arm Cover to the closed position and

tighten the #8‐32 screw to 18 in‐lbs. Once fully in-

stalled, energize luminaire to test supply wire con-

nections.

of Signify which information may be subject to change. No representation or warranty as to the accuracy or

completeness of the information included herein is given and any liability for any action in reliance thereon is

disclaimed. The information presented in this document is not intended as any commercial offer and does not

form part of any quotation or contract. All trademarks are owned by Signify Holding or their respective owners.

Page 3 of 4 P/N 443561211650

BOLSTER PLATE

CAGE NUT

Signify North America Corporation

200 Franklin Square Drive

Somerset N.J. 08873, USA

Signify Canada Ltd./Signify Canada Ltée.

281 Hillmount Road,

Markham, ON, Canada L6C 2S3