Gardco G13 Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lantern Gardco G13 herunter. Gardco G13 2 Seiten. Luminaire to roundpole

INSTALLATION INSTRUCTIONS

G13/GL13 LUMINAIRE TO ROUNDPOLE

4. Feed luminaire wires into pole. Make electrical connections and secure supply wires using the wire tie

anchor mounted to the bolster plate(Fig.3). Where more than one luminaire is mounted to the pole,

make electrical connections after all luminaires are mounted.

5. Install pole top cap.

6. Aiming arrow on reflector must match aiming direction on site plan. If reflector rotation is required, see the

following instructions:

For HID units: Loosen the four 8-32 phillips pan head screws holding the reflector to the housing. Loosen

the two thumb screws and slide latches to disengage. Remove reflector, reposition as desired and re-install.

For LED units: Remove four #8 screws and matte surrounding LED board. Remove four #8 screws holding

heatsink/light engine assembly and rotate as desired. Secure heatsink/light engine assembly with screws

previously removed. Reinstall matte with four screws previously removed.

7. Install lamp (where applicable). Make sure the lamp and wattage are as indicated in the product

identification label on the reflector. Clear lamp required for optimum photometric performance.

8. Re-install door by engaging the hinge end with the door in the almost closed position. Swing door open

and lock the hinge clamp by returning the hinge clamp lock to its original position. Re-install safety cable

through ballast clamp and onto stud. Re-install wingnut and tighten.

9. Close door making sure latch is fully engaged.

Gardco Lighting

1611 Clovis Barker Road, San Marcos, TX 78666

Gardco and Emco are Philips group brands

Fig. 3

A817129

6/6/01 - REV D

2 OF 2

A817129.CDR