Makita DCG180 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita DCG180 herunter. Makita DCG180 12 Seiten. Vezeték nélküli szigetelępisztoly
Auch für Makita DCG180: Gebrauchsanweisung (12 seiten), Gebrauchsanweisung (12 seiten), (Ungarisch) Benutzerhandbuch Handbuch (10 seiten)

Seite drucken

Lighting up the lamp

CAUTION:

Do not look in the light or see the source of light directly.

•

013570

Pull the switch trigger to light up the lamp. The lamp

keeps on lighting while the switch trigger is being pulled.

The lamp goes out approximately 10 seconds after the

switch trigger is released.

NOTE:

Use a dry cloth to wipe the dirt off the lens of lamp.

•

Be careful not to scratch the lens of lamp, or it

may lower the illumination.

When the tool is overheated, the lamp flickers.

•

Cool down the tool fully before operating again.

Drip preventive function

The motor keeps running for a short time even after the

trigger is released. It releases the pressure of the

caulking material and prevents dripping.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before carrying out

any work on the tool.

Always place the tool on the ground or workbench when

•

carrying out any assembling work. The tool without

being held tight may loose balance and cause injury.

Installing holder joint

013610

Attach the holder joint firmly along the tool, set the plate,

and fix them with screws tightly.

To remove the holder joint, follow above procedure in reverse.

1. Lamp

NOTE:

There

are

two

•

accessory), short holder (300ml) and long holder

(600ml). Use appropriate holder joint accordingly.

Installing rod and piston

013612

013611

Insert the rod into the slit of the tool.

Attach the piston and tighten it with a screw.

To remove the rod and piston, follow the installation

procedure in reverse.

NOTICE:

The teeth on the rod must point down.

•

There are three types of pistons. Piston A for

•

cartridges. Piston B for film type packs. Piston C

for direct filling.

Choose appropriate piston in accordance with the

•

type of caulking material container. Improper

piston may cause leakage or tool breakage.

There are two types of rods. The short rod for the

•

short holder (300ml), and the long rod for long

holder (600ml). Use appropriate rod in accordance

with holder type.

Always keep the rod and piston clean. Adhering

•

caulk may damage the tool.

types

holders

(optional