Airfree FIT 800 Gebrauchsanweisung - Seite 4

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Luftreiniger Airfree FIT 800 herunter. Airfree FIT 800 8 Seiten. Airfree air purifiers
Auch für Airfree FIT 800: Gebrauchsanweisung (12 seiten)

Seite drucken

Guide for Airfree

installation in mold contaminated rooms

1 - Install your Airfree

2 - Allow your unit to run for at least one week to achieve significant airborne mold spore reduction.

3 - Clean mold infected items and surfaces, since they are a continuous source of new spores.

It is important to stress that Airfree

surfaces must be cleaned manually.

Airfree

will destroy airbone molds, spores and prevents them from contaminating other areas, inhibiting the

growth of existing and new colonies.

Drill 2 vertical holes spaced apart as per the attached diagram.

After drilling the 2 holes, install the enclosed 2 screws leaving 5mm free distance from the wall.

Hang Airfree

by exercising upward pressure. If loose, please remove Airfree

screws until Airfree

Plug power cord into the nearest outlet. Make sure the surface is dry (never place Airfree

wet floor or immerge it in water). Make sure side led light is on. Adjust the night light intensity

with the touch sensor. After 10 minutes the top lid should be warm.

Place Airfree

or behind curtains as it will reduce airflow and Airfree

Check if the area is compatible with the unit capacity to achieve best unit performance. Using

Airfree in rooms larger than its capacity will greatly reduce its purifying capacity.

Airfree

However it is recommended not to place it nearby to avoid potential interference in Airfree

air flow.

Airfree

in connecting rooms.

Airfree

room.

Airfree

unit in accordance with the user manual

will not destroy or remove mold from an infected item or surface. Those

Installing and Connecting

from the two screws. Make sure Airfree

is really secured to the wall.

on a flat surface not exceeding 3' cm from the floor, not under furniture, shelves,

must be continuously on in the same room, 24 hours a day.

is to be used in rooms with minimum air volume of 330 ft

can be installed in rooms equipped with air conditioning and heating systems.

can be placed in corridors but the air sterilization effects will barely have any effect

shall not be placed near doors or under windows to avoid sterilized air to exit the

and Mold

can not be removed after installation

efficiency in reducing microorganisms.

and gradually tighten the