Avanti IM20SS Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Eiswürfelbereiter Avanti IM20SS herunter. Avanti IM20SS 17 Seiten. Avanti products ice maker

Seite drucken

IMPORTANT SAFETY INSTRUCTIONS

? WARNING ?
READ ALL INSTRUCTIONS BEFORE USING THE ICE MAKER.
DANGER OR WARNING: RISK OF CHILD ENTRAPMENT.
CHILD ENTRAPMENT AND SUFFOCATION ARE NOT PROBLEMS OF THE PAST. JUNKED
OR ABANDONED APPLIANCES ARE STILL DANGEROUS. . . EVEN IF THEY WILL "JUST
SIT IN THE GARAGE A FEW DAYS."
BEFORE YOU THROW AWAY YOUR ICE MAKER: TAKE OFF THE DOORS. LEAVE THE
SHELVES IN PLACE SO THAT CHILDREN MAY NOT EASILY CLIMB INSIDE.
NEVER ALLOW CHILDREN TO OPERATE, PLAY WITH, OR CRAWL INSIDE THE
APPLIANCE.
NEVER CLEAN ICE MAKER PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN
CREATE A FIRE HAZARD OR EXPLOSION.
D O NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND LIQUIDS
IN THE VICINITY OF THIS OR ANY OTHER ICE MAKER. THE FUMES CAN CREATE A FIRE
HAZARD OR EXPLOSION.

BEFORE USING YOUR ICE MAKER

REMOVE THE EXTERIOR AND INTERIOR PACKING.
CHECK TO BE SURE YOU HAVE ALL OF THE FOLLOWING PARTS:
1 ICE BUCKET
1 PLASTIC SCOOP
25 FT. HOSE
1 INSTRUCTION MANUAL
BEFORE CONNECTING THE ICE MAKER TO THE POWER SOURCE, LET IT STAND UPRIGHT
FOR APPROXIMATELY 2 HOURS. THIS WILL REDUCE THE POSSIBILITY OF A MALFUNCTION
IN THE COOLING SYSTEM FROM HANDLING DURING TRANSPORTATION.
CLEAN THE INTERIOR SURFACE WITH LUKEWARM WATER USING A SOFT CLOTH.

INSTALLATION OF YOUR ICE MAKER

THIS APPLIANCE IS DESIGNED TO BE RECESSED OR BUILT-IN (FULLY RECESSED).
PLACE YOUR ICE MAKER ON A FLOOR THAT IS STRONG ENOUGH TO SUPPORT THE ICE
MAKER WHEN IT IS FULLY LOADED. REMEMBER THAT THE UNIT WILL BE SIGNIFICANTLY
HEAVIER ONCE IT IS FULLY LOADED. TO LEVEL YOUR ICE MAKER, ADJUST THE LEGS AT
THE FRONT OF THE ICE MAKER.
LOCATE THE ICE MAKER AWAY FROM DIRECT SUNLIGHT AND SOURCES OF HEAT (STOVE,
HEATER, RADIATOR, ETC.). DIRECT SUNLIGHT MAY AFFECT THE ACRYLIC COATING AND
HEAT SOURCES MAY INCREASE ELECTRICAL CONSUMPTION. EXTREME COLD AMBIENT
TEMPERATURES MAY ALSO CAUSE THE ICE MAKER NOT TO PERFORM PROPERLY.
AVOID LOCATING THE ICE MAKER IN MOIST AREAS. TOO MUCH MOISTURE IN THE AIR WILL
CAUSE FROST TO FORM QUICKLY ON THE EVAPORATOR REQUIRING MORE FREQUENT
DEFROSTING OF THE ICE MAKER.
PLUG THE ICE MAKER INTO AN EXCLUSIVE PROPERLY INSTALLED-GROUNDED WALL
OUTLET. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND)
TO REDUCE THE RISK OF FIRE,
ELECTRICAL SHOCK, OR INJURY WHEN
USING YOUR ICE MAKER, FOLLOW THESE
BASIC PRECAUTIONS:
-SAVE THESE INSTRUCTIONS-

INSTALLATION INSTRUCTIONS

6