Avanti IMP25 Gebrauchsanweisung - Seite 11

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Eiswürfelbereiter Avanti IMP25 herunter. Avanti IMP25 19 Seiten. Avanti products ice maker

Seite drucken

Starting your Ice maker

Open the lid and fill the reservoir with water. Make sure the water level in the reservoir is not

over the Ice collecting tray.

Press START button to turn unit on.

Select desired ice cube size by pressing "ice size" selectors S, M and L.

Check the water level in the reservoir periodically. The ice maker will detect any shortage of

water and stop operating. The ALERT indicator will be lit. Press the STOP button and fill the

reservoir with water. W ait 3 minutes after the ALERT light goes out and then press the START

button. The Ice maker will begin operation.

When the ice cubes are collected and reaches the bin sensor, the ice maker will stop operating

and the ICE FULL indicator will be lit.

There are three sizes of ice cubes available, therefore the larger the ice cube selected, the

longer the time it will take to complete the cycle. When the ambient temperature is lower than

15°C (59ºF), the small or medium ice cubes sizes are recommended to avoid ice cubes

clumping together.

For best performance, water temperature should be between 7°C (45ºF) and 35°C (95ºF) and

ambient between 15°C (59ºF) and 25°C (77ºF).

? Cleaning Your Ice Maker

To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24

hours.

If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do

not start the system right away, wait 3 minutes, and then re -start the Ice maker.

Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not

be used for long period of time. Screw the drain plug back in place after the water has been drained.

Always change with fresh water before starting ice production at initial installation or after long

shut-off periods.

Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes.

Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice

maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil.

Rinse thoroughly before starting.

Failure to unplug the ice maker could result in electrical shock or personal injury.

? Space Requirements

During transportation, the incline angle of the cabinet should not be over 45°

Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed

system.

The Ice maker should be placed horizontally on a properly leveled surface.

To ensure proper ventilation for your Ice maker allow 6" of space at the top, the back and on each

side.

Before using the Ice maker for the first time, please wait 2 hours after positioning it.

Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently.

IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.

Operating Instructions

CARE AND MAINTENANCE

Caution

TEMPERATURE SENSOR