Lexmark 22R0010 - C 500n Color Laser Printer Menüs und Meldungen Handbuch - Seite 12
Blättern Sie online oder laden Sie pdf Menüs und Meldungen Handbuch für Drucker Lexmark 22R0010 - C 500n Color Laser Printer herunter. Lexmark 22R0010 - C 500n Color Laser Printer 15 Seiten. Setup sheet
Auch für Lexmark 22R0010 - C 500n Color Laser Printer: Einrichtung und Installation (1 seiten)
Seite drucken
Warning Messages
During warning messages, the error light is off.
Message
Calibrating
Check Output Tray
Check Toner xxxx
Duplicate IPaddr
Replace Belt CG
Replace Fuser
Replace Parts xxx
Replace WT. Pack
TMA Sensor Error
Warming Up
Service Messages
During service messages, the error light is on and the printer requires immediate assistance.
Check Front Cover
Close Back Cover
Close Front Cover
Close Top Cover
Data Error
Understanding printer messages
Action
The printer is calibrating.
Output tray is nearly full. Remove all printed media from the output tray.
The toner of color "x"—K (black), Y (yellow), M (magenta), or C (cyan),
may be up to four toners KYMC—will soon be exhausted. The remaining
toner can print only 20 to 500 images, depending on the coverage of the
toner color. You can print approximately 100–125 pages after one of the
messages comes on.
The IP address has been duplicated.
Disconnect the LAN cable, change the IP address, and reconnect the
LAN. For instructions on setting the IP address, see the Network Menu.
Replace the photodeveloper belt. For instructions on resetting the
photodeveloper belt count, see the Utility Menu.
Replace the fuser unit. For instructions on resetting the fuser count, see
the Utility Menu.
Periodic maintenance is required. This does not include replacing the
fuser unit.
The waste toner bottle is nearly full and will need to be replaced. The
printer will be able to print approximately 50 more pages and then will no
longer print until the waste toner bottle is replaced.
A calibrating error has been detected. To clear the message, turn the
printer off, reinstall the paper tray, and turn the printer on. If the error
message continues, call for service.
Note: This error only occurs when calibration mode is ON. For
information on how to turn calibration on or off, see Calibration. If
calibration is turned to OFF, print quality may be affected.
Wait for the message to clear.
The front cover is not firmly closed. Open the front cover and close it until
it locks.
Close the specified door to clear the message.
Invalid print data has been detected. To clear the message:
1 Press
to take the printer offline.
2 Press and hold
3 Press
to bring the printer back online.
12
for at least 3 seconds to clear all data.