HIKVISION DS7208HVI-ST Produkt-/Wartungshandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Produkt-/Wartungshandbuch für DVR HIKVISION DS7208HVI-ST herunter. HIKVISION DS7208HVI-ST 18 Seiten. Ds-7200hvi-st series dvr
Auch für HIKVISION DS7208HVI-ST: Technisches Handbuch (13 seiten), Schnellstart-Handbuch (9 seiten), Technisches Handbuch (9 seiten)
Seite drucken
- 1. Ds7208Hvi-St/Sn Equipment Physical Interface
- 2. Ds7208Hvi-St/Sn Equipment Internal Structure
- 3. Ds80061 Mainboard Hardware Principle Diagram
- 4. Ds80061 Mainboard Hardware Modules Diagram
- 5. Ds80061 Mainboard Hardware Module Introduction
- 6. Network Module
- 7. Power Supply Module
- 8. Ds80061 Mainboard Failure Analysis
6. DS80061 Mainboard Failure Analysis
VGA and VOUT and output image, but not at the same time output system
menu, the system default first detection VGA output, then detection VOUT
output
6.1. First Meet VGA Display
Boot to meet VGA monitor (or also meet VGA display and VOUT monitor),
BAV99 (Q6) PIN 3 low level effective, display output VGA signal and system
menu, monitor only VOUT signal
6.2. First Meet VOUT Monitor
Boot first meet VOUT monitors, BAV99 (Q9) 3 feet is high level, the high level
signal feedback to the CPU, monitor output VOUT signal and system menu,
display show only the VGA signal
Note: ① BAV99 (Q9) 3 feet high level, only output signal VGA monitor, monitor
and output signal and system VOUT menu
② BAV99 (Q9) 3 feet low level, display and VGA output signal and system
menu, monitor only output VOUT signal
6.3 Fault Analysis
①. No VGA Output
Step 1: measure 1 K resistance (RL50/51), or replacement (1 K value too large,
LVC07A chip PIN 2 VS signal output, PIN4 HS signal output voltage
value will be lower, then cause no VGA output)
Step 2: measurement 33Ωresistance (RG30/31), or replacement
Step 3: using a multimeter to measure LVC07A PIN 1 input (VS signal) voltage
about 3.3V and PIN 3 input (HS signal) voltage 3V also, and then
measure PIN 2 output (VS signal) voltage about 5V, the PIN4 output
(HS signal) voltage about 4.3V, otherwise LVC07A ruled out