Airfree Orb Kurzanleitung - Seite 5
Blättern Sie online oder laden Sie pdf Kurzanleitung für Befeuchten Airfree Orb herunter. Airfree Orb 8 Seiten.
Seite druckenWhen in Automatic Mode, the humidifier will identify room humidity level and adjust the mist
level according to below table.
Room
Humidity
The devide will turn ON
Mist Output
After 30 seconds in automatic mode without any interaction the touch button leds will change
to indicate the room humidity as per table below,
ROOM HUMIDITY
Colour of the Operating LED after
being untouched for 30s
Exclusive Orb Plus – the multi-colour Night Light System
The Airfree Orb Plus is equipped with a multi-colour light System that allows the user to choose
between a range of colours.
• To turn the lights ON touch the back of the Humidifier with the palm of your
hand.
• The multi-colour Light Ring (6) displays the following colours: red, rose, violet,
blue, light blue, green, yellow, orange, brown, grey, rainbow and random mode.
• To change the colours gently touch the back of the unit once with palm of your
hand.
• To adjust the light intensity, continuously touch the back of the humidifier until
the desired intensity is selected or switched off.
Before cleaning, switch off the unit and unplug the adapter. Never submerge the unit
or adapter in water. Please avoid tilting as water can leak from the internal mist tank
and potentially damage the device.
Remove the sphere tank. Then, remove the top lid using both hands fingers to
lift each side of the lid at the same time while pressing down the center pin in
the middle of the sphere tank grove Do not pour water just use cotton swabs
with a light mixture of neutral detergent and water to clean the tank corners,
edges, sides and bottom, than use a moist fabric and cotton swabs to remove
any detergent residue.
Clean the top lid as well with the same care as above.
Do not use water additives (e.g. essential oils, fragrances, water-conditioners). The
material is not suitable for such substances.
To clean the glass sphere tank and rubber valve assembly use neutral detergent
always remembering the sphere tank is made of glass. You may gently brush the
rubber valve assembly if necessary. Rinse thoroughly both parts to remove any
detergent residue.
Always fill the Sphere tank with filtered, distilled or clean running tap water when
reliable. If not, use bottled water. When not in use, please empty the water tank to
avoid the formation of microorganisms.
AUTOMATIC MODE
Below 30%
150ml/h
Maintenance & Cleaning
30-60%
50 - 150 ml/h
Low
Appropriate
RED
BLUE
5
Over 60%
The device will turn
OFF
High
VIOLET