Empire DVCP series Handbuch für Hausbesitzer - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Hausbesitzer für Innenkamin Empire DVCP series herunter. Empire DVCP series 12 Seiten. Direct vent zero clearance gas fireplace heater
Seite drucken
Glass Door & Barrier Screen Removal
NOTE: Do not handle barrier screen or door with your bare
hands! (Always Wear Gloves)
1.
Remove the barrier screen by lifting and pulling towards you.
2.
Locate the bottom two glass frame spring clamps. Pull
forward and downward to release them from the Glass Door
frame.
3.
Remove the Glass Door by pulling the bottom of the door
outward several inches, then lift upwards to disengage from
the firebox upper flange.
37620-0-1116
MAINTENANCE AND SERVICE
Figure 4
Figure 5
Install Glass Door and Barrier Screen
1.
When installing the Glass Door assembly, make sure that the
door top flange is hooked over the firebox top flange as illustrated
in the "Correct" view in Figure 6.
Important: Do not allow the gasket across the top of the
door to roll up on top of the firebox flange as shown in
"Incorrect" view in Figure 6.
2.
To install correctly, the door should be held at an angle outward
from the firebox as shown in the illustration, then carefully engage
the upper flange of the door frame with the top flange of the
firebox. Center the door left to right, then allow the bottom of
the door to swing inward to seal against the firebox front.
3.
Once the glass door is placed flat to the firebox front edges,
engage the two spring latches to the bottom flange on the glass
door frame to secure the door assembly.
4.
Replace the barrier screen assembly by hooking the top of the
glass door and aligning the lower hook with the glass panel.
GASKET
FIREBOX
TOP
FIREBOX
TOP
Figure 6
Page 7