KitchenAid YKERS306BSS1 Installationsanleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Ranges KitchenAid YKERS306BSS1 herunter. KitchenAid YKERS306BSS1 16 Seiten. 30" (76.0 cm) freestanding electric ranges

Seite drucken
Style 2: Ranges Equipped with a Warming Drawer or Premium
Storage Drawer:
Use a wrench or pliers to adjust leveling legs up or down until
the range is level. Push range back into position. Check that
rear leveling leg is engaged in the anti-tip bracket.
NOTE: Range must be level for satisfactory
baking
performance and best cleaning results using AquaLift ®
Technology and Steam Clean functions.
Remove all items from inside the warming drawer or premium
storage drawer, and allow the range to cool completely before
attempting to remove the drawer.
To Remove:
1. Open the warming drawer or premium storage drawer to its
fully open position.
2. Using a flat-blade screwdriver, gently loosen the warming
drawer or premium storage drawer from the glide alignment
notch and lift up the drawer alignment tab from the glide.
A
A. Flat-blade screwdriver
B. Drawer alignment tab
C. Drawer glide notch
3.
Repeat Step 2 on the other side. The warming drawer or
premium storage drawer is no longer attached to the drawer
glides. Using both hands, pick up the warming drawer or
premium storage drawer to complete the removal.
To Replace:
1. Align the forward drawer notches with the notches in the
drawer glides on both sides. Place the rear alignment tabs into
the drawer glides on both sides.
3. Gently open and close the warming drawer or premium
storage drawer to ensure it is seated properly on the glides on
both sides.
(o_'_} s ome modes}
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back to the drawer stop.
/
2
.J
A
2.
To
1.
2.
3.
A. Drawer stop notch
Lift up the front of the drawer and pull the drawer out.
Replace:
Lift up the front of the drawer and place the rear of the drawer
inside the range so that the drawer stop notch is behind the
drawer glide.
Lower the drawer so that the edge of the slide rail drops into
the slot in the drawer glide.
Slowly push the drawer into the range.
A
\
A. Engage drawer glide.
NOTE: When properly installed, the rear slides on the bottom
of the drawer will engage the base rails and the drawer will not
tip when items are placed in the drawer.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Pinch the hinge latch between two fingers and pull forward.
Repeat on other side of oven door.
2.
A. Drawer alignment tab
B. Drawer glide notch
Push the warming drawer or premium storage drawer in all the
way.
A. Hinge latch