Jancy Engineering Slugger 2x2 17980 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Bohrer Jancy Engineering Slugger 2x2 17980 herunter. Jancy Engineering Slugger 2x2 17980 16 Seiten. Slugger portable magnetic drilling machine

Seite drucken
1. The motor slide may require adjustment after machine has been in service. Loosen jam nuts using provided wrench.
Using feed handles, position motor/slide assembly in the full up position. Using supplied hex key, equally turn
adjustment screws clockwise to increase slide tension or counterclockwise to decrease slide tension. Do not over tighten
adjustment screws. Excessive slide tension can damage the machine. Properly adjusted, the motor/slide assembly
should have no side to side movement and remain in the fully up position without drifting down.
2. Keep bottom of magnet clean, free of chips, burrs, nicks, oil and other contaminants. Inspect magnet face
to ensure surface is flat and square. A worn magnet surface dramatically reduces magnetic holding force.
3. Periodically lubricate motor slide ways with lithium base grease.
5. Arbor runout should not exceed .0035 inches per revolution. This is most accurately measured by placing a dial
indicator needle inside of arbor bore and rotating arbor while observing indicator.
6. Inspect motor brushes and replace as needed.
7. Replace any worn parts and regularly tighten fasteners that have become loose during usage.
8. Regularly test machine by placing machine on non-ferrous material. Engage magnet switch. Motor should not continue
running when motor on button is released.
10

regular maintenance

dimensions and specifications
Height
Width
Length
Weight
Motor
Spindle Bore
Arbor Bore
Drill Point Breakaway
Magnet Base Dimensions
Magnet Dead Lift
Slugger Cutter Diameter (Maximum)
Slugger Depth of Cut (Maximum)
:
1"
note
magnetic
base
requires
1-3/8"
ing
and
larger
diameter
21"
8"
12"
36-1/4 lbs.
1.6 HP 1200W (single phase)
120V / 10.2A ~ 240V / 5.1A
210 / 420 RPM (no load)
#2 morse taper
3/4"
1111 lbs. on 1" plate
3-1/2" x 8"
2657 lbs. on 1" plate
2"
2"
minimum
material
thickness
when
holes
-
drill