AirGenerate airtap Installationshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationshandbuch für Warmwasserbereiter AirGenerate airtap herunter. AirGenerate airtap 8 Seiten.

Step-by-Step Instructions

10. Put Teflon tape on the ¾" nipple thread and attach the ¾" Flange Adaptor

to the ¾" nipple. Tighten the Flange Adaptor with your adjustable wrench

with enough force to prevent leakage. Put Teflon tape to all the threads of

the 'T' Adaptor. Attach the 'T' Adaptor to the Flange Adaptor and tighten

it using a pipe wrench.

11. Now you can attach the AirTap

on top of the existing water heater. You may need some help, as the unit

weighs around 48 lbs. Determine where the AirTap

on the brackets by aligning the holes in the desired position. The AirTap

should be positioned as close to the inlet and outlet nipples as possible for

maximum stability (For gas water heater installations, the AirTap

be at least 1" away from the outer edge of the vent pipe.). Once this is

determined, slide the two mounting bolts in the appropriate holes

on the brackets and secure with the nuts provided.

12. Unwrap and carefully straighten the copper coil connected to the

AirTap

. You may need some help for this. Insert the coil into the top of

™

the 'T' Adaptor pipe previously installed, holding the two lines together.

An initial jerk may be needed to push the tube. The tube will curl in the

tank. Continue inserting the coil into the tank, but never try to force it in.

If it gets stuck, gently give it a push until it continues into the tank. The

thermostat bulb should be inserted at the end. Use extra care when you

reach the thermostat bulb and make sure it is immersed along with the

coil. Continue inserting until the entire coil is in the tank.

USE CAUTION during the immersion process to ensure that no crimping of the

coil or thermostat capillary takes place, including the section from the insertion

nipple to the back of the AirTap

curve with more than a 2" radius.

13. Apply teflon tape to the threads on the exposed end of the outlet nipple

previously installed. Screw the brass female adaptor onto the nipple and

tighten securely. Tighten all adaptors.

to these brackets so that the unit rests

™

will be positioned

™

. At no point should you allow the coil to

™

should

™