KitchenAid 3183659 Installationsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanweisung für Backofen KitchenAid 3183659 herunter. KitchenAid 3183659 7 Seiten. Electric built-in 24” and 27” thermal single and double ovens 24” and 27” thermal convection single and double ovens

Seite drucken
Now start...
with oven in kitchen.
Remove shipping materials, tape, and
protective film from oven.
Do Not
remove shipping base at this time.
Remove the racks and other parts
from inside the oven.
Personal Injury/Product
Damage Hazard
l
Use both hands to remove oven doors.
l
Grasp only the sides of oven doors.
l
Do Not use handle or any portion of the
trim for lifting.
l
Because of the weight and size of the
single or double oven, two or more
people are needed to move and safely
install the oven.
Failure to properly grasp the oven doors
or to lift ovens properly could result in
damage to the product or personal injury.
Completely open the lower oven door.
Remove the two oven door screws. (Not
all models have oven door screws.)
Close lower oven door to the broil position.
Grasp the sides of the oven door and pull the
door up and out of the hinge slots to remove
Set door aside.
Repeat Steps 3 and 4 for upper oven
door.
Product Damage
Before moving oven across floor, check
that oven is on shipping base or slide
single or double oven onto cardboard or
hardboard.
Failure to follow these instructions
may
result in damage to floor covering.
Turn power supply off. Move oven close
to final oosition. Remove and discard
shipping base. 'Feed appliance cable through
the opening in cabinet. Make electrical
connection.
See "Electrical requirements"
and
"Electrical connection"
sections, Panel C.
Product Damage
Carefully push against the seal area of the
oven front frame when pushing the oven
into the cabinet.
Do Not push against outside edges.
Failure to follow these instructions
can
result in damage to oven finish.
Remove and discard shipping base. Lift
oven up into cabinet cutout using the oven
opening as an area to grip.
Push against seal area of front frame to push
oven into cabinet.
-
0
c
0
\
: 4 screws
Center oven into cabinet cutout. Use
two screws (four screws for a double
oven) through the mounting holes in the front
frame of the oven to secure the oven to the
cabinet. Do Not overtighten
screws.
Iv-
y
\ B
this position.
Install the lower vent grille using the
three screws provided.
Replace the oven racks.
Replace the single oven or
upper double oven door
by
partially fitting the door
hinges into the hinge slots.
Pull door slightly toward you;
then slide door completely
in
place. Reinstall the two
oven-door screws (if required
for your oven door). If door does not close, you
have not pushed hinges completely
into frame.
Repeat for lower oven door.
11.
Numbers
correspond
to steps.
Panel D