KitchenAid KEBC167MSS01 Einbauanleitung - Seite 2
Blättern Sie online oder laden Sie pdf Einbauanleitung für Backofen KitchenAid KEBC167MSS01 herunter. KitchenAid KEBC167MSS01 5 Seiten. 36" electric built-in single oven
27-I/2"
recessed
height
29" max.
recessed
depth
34-3/8"max.
recessed
width
29" max.
overall
height
Your safety aed the safety of others are
very important.
We have provided many important safety
messages in tills manualand on your appliance.
Atways read and obey aII safety messages.
This is the safety alert symbol.
This symboi alerts you to potential hazards
that can kiii or hurt you and others.
Ati safety'messageswiii foiiow the safety alert
symbol and either the word "DANGER"or
"WARNING".Thesewords mean:
You can be killed or seriously injured if you
don't follow instructions.
AIi safety messages wiii teii you what the potential
hazardis, tell you howto reducethe chance of
injury, and teti you what can happen if the
instructions are not followed.
[
27-3/4"
min.
cutout
height
"_---
36" min.
cabinet width
l
34-1/2"
_F-
cutout width
5-1/4" bottom of
cutout
to floor
SingLe undercounter
oven
(without cooktop
installed above)
cabinet
--_-
36" min.
--
cabinet width --a_,*
27-3/4"
min.
cutout
height
1-1/2 _ mira
bottom of
cutout to
top of
cabinet
door
34-1/2"
_<---
cutout --
width
1" top of cutout
to
bottom
of upper
cabinet door
t
32"
bottom
of
cutout
to
floor
23-1/4"min.
cutout
depth
23"recessed
oven depth
recessed
oven
Cabinet side view
oven
_front
iMPORTANT: Observe all governing
codes
and ordinances.
Proper installation is your responsibility.
Have a qualified technician install this oven.
Oven location should be away from strong draft
areas, such as windows, doors and strong
heating vents.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance.
Recessed installation area must provide
complete enclosure around the recessed portion
of the oven.
Electrical ground is required. See "Electrical
requirements."
Electrical supply junction box should be located
3 inches maximum below the support surface
when oven is installed in a wall cabineL Drill a
14nch minimum diameter hob in the right rear
or left rear corner of the support surface to pass
the appliance cable through to the junction box.
For undercounter installation, it is recommended
that the junction box be located in the adjacent
right or left cabinet, if installing the junction box
on rear wall behind oven, junction box must be
recessed and located in the upper or lower right
or left corner of cabinet.
Oven support surface must be solid, level and
flush with bottom of cabinet cutout.
it is the customer's responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is
adequate and in conformance with National
Electrical Code, ANSI/NFPA 70 -- latest edition%
and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
Tool needed:
, Phillips screwdriver
Parts supplied:
• 2 screws
Page 1