Jandy CPLVLEDP100 Installationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Installationshandbuch für Beleuchtungsanlagen Jandy CPLVLEDP100 herunter. Jandy CPLVLEDP100 16 Seiten. Watercolors led lights underwater large and small light
Auch für Jandy CPLVLEDP100: Installationshandbuch (20 seiten)

Seite drucken

Page 12

English

WARning

Risk of Electrical shock or Electrocution. Always

install a new lens gasket whenever disassembling the

light (Jandy Color Light Gasket P/N R0451101 for large

light and P/N R0400501 for small light). Failure to do

so may permit water to leak into the assembly, which

could cause:

(a) An electrical hazard resulting in death or serious

injury to pool or spa users, installers, or others due to

electrical shock, or

(b) A malfunction of the Jandy WaterColors Light,

which likewise could result in serious injury to pool or

spa users, installers, or bystanders, or in damage to

property.

White (12V)

Red (120V)

Nylon

Washer

Nut

Figure 7.

small light Engine (PCB) Replacement

and Wiring

Nylon

Washer

Nut

Figure 8.

large light Engine (PCB) Replacement

and Wiring

Jandy

Pro Series, WaterColors LED Lights

Green

Black (12V)

Blue (120V)

Light

Engine

AC1

AC2

Secure

First

Green

White

Black

12V Wiring

b. While holding the fixture upright, place the glass

lens with the gasket on top of the fixture. Please

note that the lens gasket is not symmetrical.

Therefore, it must be installed correctly so that

the lens can seal to the fixture housing. Place the

gasket on the lens so that the thick molded side

of the gasket will mate with the housing when

the lens is installed, see Figure 10. On the small

light, replace the diverger by tucking the tabs

between the lens and gasket.

nOTE

Be sure to face the dull side of the diverger down

towards the PCB.

c. Position the lens and gasket on the fixture. Place

the face ring assembly over the lens and align

the pilot screw with the small arrow mark on the

face of the lens. Note that the small arrow mark

on the face of the lens and the pilot screw of the

face ring must be aligned with the arrow located

on fixture label that reads, "Arrow on this label

must line up with the pilot screw on the Face

Ring". See Figure 9.

d. While holding the aligned face ring assembly

and fixture together, turn the assembly upside

down and set it on the old gasket, using the old

gasket as an assembly fixture. This will keep the

lens and gasket assembly from being pushed out

of the face ring while you secure it to the light

fixture.

e. Spread the bottom clamp over the electrical cord

and slide it onto the back of fixture to the top

clamp.

Tighten the Phillips head screws (eight (8) for

large light and six (6) for small light) on the

light in alternating cross-pattern. Torque screws

to approximately 20 in-lbs. Do not over-tighten.

g. Discard the old gasket.

White

Green

Nut

Secure

First

120V Wiring

Installation Manual

Black

Secure

First