Garden Treasures F11434AA Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Außen-Brunnen Garden Treasures F11434AA herunter. Garden Treasures F11434AA 3 Seiten. Buddha fountain

Seite drucken
FOUNTAIN ASSEMBLY INSTRUCTIONS:
1.
Unpack the Styrofoam and bubble warp inside the contents of the box and check to make sure that all items are accounted for and in good condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Position the base in the desired location and route the low voltage power cord from the pump through the pipe in the base. The underside of the
base will have a notch that will allow the base to sit level with the power cord underneath.
4.
Fill the base with clean water. The water should be approx. 2 inches below the top edge of the base.
5.
Attach the water supply tube from the bottom of the Buddha statue to the outlet on the water pump.
6.
Connect the LED light output pin to the LED light input cord.
7.
Make sure the tubes and power cord are connected firmly and tightly before placing the Buddha statue onto the base. The Buddha statue should sit
securely on the base.
8.
Connect the power cable to the power source, and the unit will start working as intended.
9.
To eliminate the possibility of water damage to areas around your fountain, check for leaks and excessive splashing after the initial setup of your
fountain. It is highly recommended that this fountain be placed in an area that will not be damaged should the area come in contact with liquid.
10. Do not leave your fountain running for extended periods of time when no one is present to observe the performance.
11. Check the area around your fountain on a regular basis to ensure that there is no leakage.
NOTE: The diagrams are not to scale and are shown are for illustrative purposes only.
Pump Maintenance Instructions
•
Regular cleaning of the pump is necessary.
•
Keep water clean to prolong the life of pump.
•
Clean pump when it is dirty or when a drop in performance is detected. Use warm, soapy water and a stiff brush for heavily stained surfaces Do NOT
use harsh chemicals, as this will damage the surface finish.
•
Failure to clean the pump will result in overheating and voiding of the warranty.
•
Use a filter on pump if available.
•
Disconnect the power and empty the reservoir if the fountain will not be used for an extended time.
•
Do NOT operate fountain in temperatures below 41°F (5°C). Freeze damage may occur. If the fountain is kept outdoors in freezing temperatures,
make sure all water is removed and the unit is completely dry.
To disassemble pump for cleaning:
1.
Always disconnect pump from the power source before cleaning.
2.
Remove the inlet screen and impeller housing.
3.
Remove the impeller/rotor assembly by gently pulling on the impeller blades.
4.
Use a soft cloth or brush to clean the impeller/rotor assembly area inside the pump.
5.
Clean the inlet screen, impeller housing and impeller with warm, soapy water.
6.
Reassemble the pump and check for proper operation.