KitchenAid KEDO-270SE Einbauanleitung - Seite 4
Blättern Sie online oder laden Sie pdf Einbauanleitung für Backofen KitchenAid KEDO-270SE herunter. KitchenAid KEDO-270SE 4 Seiten. Electric built-in single & double ovens
Seite drucken
.
INSTALLING
THE UNIT IN CABINET
The doors should
be removed to decrease the weiaht
of the oven and provide
a better hand hold on the
oven while lifting
it into the cabinet.
A. To Remove Doors (See Fig. 1)
Use caution!
Oven door is heavy.
1. Open door completely.
2.
Depress finger tab in oven door hinge area. Push tab toward
oven. Lift tab away from door liner and slide toward
top of
oven door.
3.
Repeat step 2 for other side of door.
4.
Close door
until
approximately
5 inches from fully
closed
position.
5.
Slide door off the hinge arm assemblies.
6.
Repeat steps 1 through
5 for other
door on double
ovens.
Be sure that mica spacers at either side of oven are in place to pro-
vide proper air flow between cabinet and oven.
When oven has been placed into cabinet,
the bottom
trim
strip
is
placed on lower edge of front
frame. This is done by loosening
the
three screws at the bottom
of the front
frame. Slide the trim strip
under the screw heads until
the strip meets the lower corners of the
front
frame
(See Fig. 2). Tighten
screws to hold to front
frame.
Secure oven to cabinet
with #8 flat head screws supplied
with oven.
Disregard any excess screws.
B. Replace Oven Racks in Oven Cavity.
C. Reinstall
The Door(s) (See Fig. 1)
1. Slide door hinge arms until firmly
seated.
2.
Lower door to full open position.
3.
Push finger tabs to back. Depress the tabs and slide forward.
4.
Close and reopen
door
slowly
to make sure it has been
replaced properly.
5.
Repeat steps 1 through
4 for other door on double
oven.
DOOR ADJUSTMENT
CHECK
/r
NEWSPAPER
STRIPS
TOP OF DOOR
NE WSPAPER
STRIPS>
8t DTTOM OF DOOR
DOOR
IN FULL
OPEN
POSITION
Place
2"
x 18"
strips
of newspaper
in lo-
cations
indicated
by illustration.
Allow
one
end
of the paper
to extend
into
the oven
cavity.
Pull gently
at each piece of paper.
If
door
is properly
adjusted,
each
piece
of
paper
will
offer
firm
resistance
when pulled.
When
door
is out
of adjustment,
slide unit
out
far
enough
to expose
hinges
on each
side.
Loosen
screws
and
move
bottom
of
door
to a proper
fit.
After
completing
ad-
rustment
tiqhten
all screws
in hinges.
ADJUST
UP OR DOWN>
TO ALIGN
DOOR
Specifications
Subject
to Change Without
Notice
FORM
15457
(6-84)
\HOBARTI
TROY,
OHIO
45374
PRINTED
IN U.S.A.