Gardena 300 C Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Rasenmäher Gardena 300 C herunter. Gardena 300 C 8 Seiten. Cylinder lawnmower

Adjusting the cutting height :

5. Putting into Storage

Storage :

Cleaning the mower :

After relatively long intervals between mowing (e.g. holiday), first of

all cut in one direction with the cutting height as high as possible

(42 mm), then cut in the crosswise direction at the cutting height

required. The blades of grass should not be more than 12 cm

long if they are to be cut with a cylinder mower.

If possible only cut the grass when it is dry. If the grass is damp,

the cutting pattern will be uneven.

The cutting height can be set to any

position between 12 mm and 42 mm.

1. Stand behind the cylinder mower

with one foot on the roller

2. Slacken the two locking screws

and set to the height required on

the scale

3. Tighten the two locking screws

on both sides to the same height.

The locking screws

both sides.

The mower may only be adjusted to a depth in which the lower

blade does not touch the ground when it is uneven.

v Clean cylinder mower before storage (see 6. Maintenance) and

store in a dry place.

To save space the cylinder mower can be collapsed by opening

up the clamping nuts.

DANGER ! Cutting mechanism can cause injuries !

V Wear suitable work gloves when undertaking

maintenance.

WARNING ! Damage to cylinder lawnmower.

V Never clean your cylinder lawnmower with running

Always keep the lawnmower clean and remove grass deposits.

Deposits affect the cutting result as well as discharge of grass

clippings. Residual dirt and grass is easily removed immediately

after mowing.

1. Remove grass deposits with a brush and a cloth.

2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayed

oil).

must always be set to the same height on

water, in particular with water under high pressure.