Gardena PowerMax 30/18V P4A Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasenmäher Gardena PowerMax 30/18V P4A herunter. Gardena PowerMax 30/18V P4A 14 Seiten. Battery lawnmower

Seite drucken
To replace the blade [ Fig. T1 / T2 ]:
DANGER! Risk of physical injury!
Cut injury when the blade turns and it is damaged, bent, out of
balance or has chipped edges.
v Do not use the mower when the blade is damaged, bent, out
of balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are available from your GARDENA dealer or
from the GARDENA service.
v Only use an original GARDENA Blade
For safety reasons, we recommend that the blade be replaced by
GARDENA Service or by an authorised GARDENA dealer.
1. Insert a screwdriver into one of the proviced holes at the bottom of
the housing
(28)
.
The screwdriver thus serves as a stop for the blade.
(25)
2. Unscrew the blade bolt
.
Make sure that the spacer
(24)
(25)
3. Remove the blade bolt
and the washer
4. Remove the blade
(27)
.
(27)
5. Put the new blade
on the mower. The inscription on the knife
(this side to grass) must be visible.
(26)
6. Put the washer
and the blade bolt
7. Screw the new blade
(27)
tight with the blade bolt
15 – 20 Nm). Do not over-torque.
Make sure that the spacer
(24)
8. Pull the screwdriver out of the mower.
Make sure that the screwdriver is removed before restarting the mower
again.
Problem
Possible Cause
Engine is jammed and
Motor is blocked.
makes a noise
Cutting height is too low.
Loud noises, the mower
Screws on engine, its fixing
is rattling
or on the mower chasing are
loose.
Mower runs unevenly or
Blade is damaged / worn or the
vibrates strongly
blade mounting is released.
Blade is very dirty.
Lawn is not cleanly mowed
Blade is blunt or damaged.
Cutting height is set too low.
Mower does not start
Battery is empty.
or stops
Battery temperature is outside
the permissible temperature
range.
There are drops of water or
moisture between the battery
contacts on the mower.
Engine is blocked.
Product is defective.
Battery is not put completely
into the battery holder.
Safety key is not in positon 1.
Battery is defective.
Charging is not possible.
The battery is not connected
Green battery charge
(correctly).
(Lc)
indicator
is continously
Battery contacts are dirty.
lit [ Fig. O3 ]
Art. 4120
is not damaged when applying the force.
(26)
.
(25)
on the mower.
(25)
(tightening torque is
is not damaged when applying the force.
Remedy
v Remove the obstacle.
v Raise the cutting height.
v Let the screws be tightened
by an authorised specialist
dealer or the GARDENA
Service.
v Replace the blade
(see To replace the blade).
v Clean the mower
(see 4. MAINTENANCE).
If this does not rectify the
problem, contact the
GARDENA Service.
v Replace the blade
(see To replace the blade).
v Raise the cutting height.
v Charge the battery.
v Wait until the battery tem-
perature is between 0 °C –
+ 45 °C again.
v Remove the water drops /
moisture with a dry cloth.
v Remove the obstacle.
Start again.
v Contact the GARDENA
Service.
v Put the battery completely
into the battery holder until it
audibly engages.
v Turn the safety key to
position 1.
v Replace the battery.
v Connect battery to charger
correctly.
v Clean the battery contacts
(e. g. by connecting and
disconnecting the battery
several times. Replace the
battery if necessary.
Problem
Possible Cause
Charging is not possible.
Battery temperature is outside
Green battery charge
the permissible charging tem-
(Lc)
indicator
is continously
perature range.
lit [ Fig. O3 ]
Battery is defective.
Green battery charge
Mains plug of the charger is
(Lc)
indicator
is not
not (correctly) plugged in.
illuminated
Socket outlet, mains cable or
[ Fig. O3 ]
charger is defective
NOTE: For any other malfunctions please contact the GARDENA service depart-
ment. Repairs must only be done by GARDENA service departments or specialist
dealers approved by GARDENA.

7. TECHNICAL DATA

Battery Lawnmower
Unit
Speed of rotation cutting
rpm
blade
Cutting width
cm
Cutting height adjustment
mm
(3 positions)
Volume of grass box
l
Weight (without Battery)
kg
Sound pressure level L
1)
dB (A)
pA
Uncertainty k
pA
Sound power level L
:
2)
WA
measured/guaranteed
dB (A)
Uncertainty k
WA
Hand/arm vibration a
1)
m/s
2
vhw
Uncertainty k
vhw
Measuring process complying with:
EN IEC 62841-4-3
1)
Note: The stated vibration emission value has been measured according to
a standardized test procedure and can be used for comparison of one electric
power tool with another. It can also be used for preliminary evaluation of
exposure. The vibration emission value can vary during actual use of the electric power
tool depending on the ways in which the machine is used. As a safety measure, you
should work with the machine for a maximum of 1 hour without interruption.
System Battery
Unit
PBA 18V 4.0Ah W-C
Battery voltage
V (DC)
Battery capacity
Ah
Number of cells (Li-Ion)
Appropriate POWER FOR ALL system Battery Chargers: AL 1810 CV / AL 1815 CV / AL 18V-20 /
AL 1830 CV / AL 1880 CV.
Battery Charger
Unit
AL 1810 CV P4A
Mains voltage
V (AC)
Mains frequency
Hz
Rated power
W
Battery charging voltage
V (DC)
Max. battery charging
mA
current
Battery charging time
80 % / 97 – 100 % (approx.)
PBA 18V 2.0Ah W-B
min.
PBA 18V 2.5Ah W-B
min.
PBA 18V 4.0Ah W-C
min.
Permitted charging
°C
temperature range
Weight according to
kg
EPTA-Procedure 01:2014
Protection class
Appropriate POWER FOR ALL system Batteries: PBA 18V.
Remedy
v Wait until the battery tem-
perature is between 0 °C –
+ 45 °C again.
v Replace the battery.
v Insert the mains plug into the
mains socket (completely).
v Check the mains voltage.
Let the charger be checked
if necessary by an authorised
specialist dealer or the
GARDENA Service.
Value (Art. 14630)
3500
30
35, 50, 65
25
8
73
3
87 / 89
0.7
≤ 2.5
1.5
RL 2000/14/EC / S.I. 2001 No.1701
2)
Value (Art. 14905)
18
4.0
10
Value (Art. 14900)
220 – 240
50 – 60
26
18
1000
96 / 124
120 / 154
192 / 244
0 – 45
0.17
/ II
15