Gardena R40Li Kurzanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Kurzanleitung für Rasenmäher Gardena R40Li herunter. Gardena R40Li 2 Seiten. Robotic lawnmower
Auch für Gardena R40Li: Kurzanleitung (2 seiten)

Seite drucken
Gardena R40Li Kurzanleitung
Getting started with
GARDE NA R40Li
1
Placement of and connecting the charging station
See chapter 3.2 in the Operator's Manual.
1. Place the charging station at a central position in the work
area, with a lot of open space in front of the charging
station and on a relatively horizontal surface.
2. Connect the transformer's low voltage cable to the
charging station and the transformer.
3. Connect the transformer to a 230 V wall socket.
2
C harging the battery and placement
of the boundary wire
See chapters 3.3 and 3.4 in the Operator's Manual.
1. Place the R40Li in the charging station to charge
the battery while you are laying the boundary wire.
Set the main switch to position 1.
2. Run the boundary wire ensuring it forms a loop
around the work area.
3. Make an eyelet at the point where the guide wire
will be connected later (see point 4.5).
10 cm / 4"
20 cm / 8"
2
1. Main switch
2. STOP button
3. LED for function check of the
boundary and guide wires
4. Cutting height indication
5. Display
6. Keypad
3
2
0 cm / 0"
4
1
2
3
4
5
3
GARDENA
5
Start
1
2
3
6
4
5
6
1
7
8
9
0
3
2
4
5 cm / 2"
30 cm / 12"
Charging station
Transformer
Connecting the boundar y wire
See chapter 3.5 in the Operator's Manual.
1. Open the connector and lay the wire ends in the recesses on
each connector.
2. Press the connectors together using a pair of pliers.
3. Cut off any surplus boundary wire. Cut 1 to 2 cm above the
connectors.
4. Press the connectors onto the contact pins, marked A, on
the charging station. It is important that the right-hand
wire is connected to the right-hand contact pin, and the
left-hand wire to the left-hand pin.
Placement of and connecting
the guide wire
See chapter 3.6 in the Operator's Manual.
1. Run the guide wire through the slot at the bottom of the
charging station.
2. Fit the connector to the guide wire in the same way as for
the boundary wire, according to the instructions above.
3. Fasten the connector to the contact pin marked Guide on
the charging station.
4. Lay the guide wire at least 2 metres straight out from the
front edge of the charging station.
5. Run the guide wire to the point on the boundary loop the
connection will be made. Avoid laying the wire at tight
angles.
6. Cut the boundary wire with a wire cutters at the centre of
the eyelet that was made in point 2.3.
7. Connect the guide wire to the boundary wire using the
accompanying couplers. Press the couplers completely
together with a pair of pliers.
Low voltage cable
Boundary wire
and couplers
1
2
3
4
1
1
7
min 2 m / 7 ft
4
Staples
Connectors
Measurement
gauge