Gardena 4000/4 LCD Betriebsanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Water Pump Gardena 4000/4 LCD herunter. Gardena 4000/4 LCD 17 Seiten. Electronic pressure pump
Seite drucken
- 1. Table of Contents
- 2. Suitable Uses for Your GARDENA Elelctronic Pressure Pump
- 3. Function and Display
- 4. Safety Instructions
- 5. Using the Equipment for the First Time
- 6. Operation
- 7. Maintenance
- 8. Preparation for Storage
- 9. Troubleshooting / Service
- 10. Accessories Available
- 11. Technical Data
- 12. Warranty
Normal mode
(standby)
Press shift key.
Press shift key.
Press shift key to return to throughput display, pressure display or standby.
and
RESET key:
In some circumstances ERROR 06 may appear. This does not
impair the further operation of the pump.
8. When the pump has drawn in the water, turn the rotary switch
to RUN.
9. Close shut-off devices in the delivery pipeline again.
The pump switches off automatically when the maximum
pressure is reached. Normal mode (standby) has been reached
(
).
Change display information:
In operation:
Throughput display in
l/h
(in 100 l/h increments)
In operation:
Pressure display
in bar.
(in 0,2 bar increments)
Normal mode
(display for 3 seconds)
Press shift key.
Normal mode
(display for 3 seconds)
automatically return to throughput display or standby after one minute..
Reset quantity delivered display
If the RESET key is pressed whilst
conveyed in m
This permits the quantity delivered to be measured at any desired
time interval.
➔ Hold RESET key down for 2 seconds.
Restart after a fault:
If a fault has occurred, the pump can be switched on again
prematurely by pressing the RESET key.
➔ Press RESET key.
The frost symbol goes out after the RESET key is pressed.
Press shift key.
3
since last reset) only the
Standby:
Pump has reached
max. pressure.
Quantity delivered in
m
3
since first start-up
(display for 3 seconds)
Quantity delivered in
m
3
since last reset.
(display for 3 seconds)
:
is operating (quantity
display is reset to 0.
19