Gardena WLP 300 B Betriebsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Water Pump Gardena WLP 300 B herunter. Gardena WLP 300 B 10 Seiten. Indoor fountain pump / water light jet pump 9 v

Seite drucken

1. Operation

Check line voltage

Check line voltage. Data indicated on the type plate must match

technical data of the mains supply.

Do not operate pump

The pump must not be operated when there are people in the

when people are in water

water.

Do not use power cable

Do not use the power cable to carry the pump or to pull the

to carry the pump

plug. Protect the power cable from heat, oil and sharp edges.

Disconnect plug

Please unplug the pump after operation and before carrying out

any maintenance works.

Temperature of the liquid

The temperature of the liquid used must not be below 4 °C or

used

above 35 °C.

Wear and reduced

Sand and other abrasive substances in the liquid cause in-

output

creased wear and reduce the output of the pump.

Caution !

GARDENA pumps and plug connections have been designed

9 V low voltage

exclusively for the use with 9 V low voltage. When connected

to 230 V your life is at risk! Operate the pump only with the

delivered transformer.

Do not expose the

Do not expose the transformer to direct sunlight.

transformer to sunlight

Operation

Installing the pump

Before operation submerge the pump in the water. Take care that

the pump is positioned in a way that the casing is completely

immersed in water.

The foam filter at the bottom must not be covered up at the

side!

Caution : Submersion depth

Please note the maximum submersion depth (see "Technical Data").

Switching on the pump

Put the plug of the pump into the socket of the mains plug and

then the mains plug into a 230 V AC socket.

Caution! Pump will start immediately.

Volume regulator

Adjust the volume according to your needs by turning the volume

control. (➔ Turning anti-clockwise increases the volume)