Gardena 1242 Betriebsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Rasen- und Gartengeräte Gardena 1242 herunter. Gardena 1242 15 Seiten. Programming unit
Auch für Gardena 1242: Betriebsanleitung (15 seiten), Betriebsanleitung (15 seiten)

Seite drucken

Manual watering :

Setting the manual

watering time :

6. Trouble-Shooting

Fault

No display

Battery flat after a short

operating period

Faults during data

transmission

ERROR 1

flashes on the display

(no connection to

Control Unit)

Manual Watering

Prerequisite :

The lever of the Irrigation Valve must be set to the "AUTO"

position.

1. Press the ON / OFF key on the Control Unit.

Manual watering starts.

2. Press the ON / OFF key on the Control Unit during manual

watering.

Manual watering is ended prematurely.

After putting the Programming Unit into operation, the manual

watering time is pre-set to 30 minutes (

1. Call the main level. The time and day are displayed.

2. Press and hold down the Ok key for 5 seconds.

MANUAL RUN-TIME

and the hours flash.

3. Set the hours for the watering time using the

(for example

hours) and confirm by pressing the Ok key.

MANUAL RUN-TIME

and the minutes flash.

4. Set the minutes for the watering time using the

(for example

minutes) and confirm by pressing the Ok key.

The changed manual watering time is saved in the Program-

ming Unit and the main level is displayed.

Tip : If you have questions about programming the Programming

Unit, please do not hesitate to contact GARDENA Service.

Possible cause

Energy-saving stand-by mode

has switched on.

No battery or battery flat.

Outside temperature

below – 10 °C or

above

Alkaline battery was not used.

Plug connection dirty.

Control Unit not connected

or connected incorrectly.

No contact at the plug con-

nection.

No battery in the Control Unit.

0 : 30

Remedy

v Press any key.

The display shows the main

level.

v Insert battery (refer to

4. Putting into Operation).

v Wait until the operating

+ 50 °C.

temperature range is

reached again.

v Use an alkaline battery of

the type 9 V IEC 6LR61.

v Clean using a soft cloth or

brush (do not use solvent).

v Connect Control Unit

completely, push on as

far as possible.

v Check contact at the plug

connection.

v Replace battery in Control

Unit.

keys