Makita XST01Z Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Elektrowerkzeug Makita XST01Z herunter. Makita XST01Z 10 Seiten. Cordless oil-pulse driver

Seite drucken

FUNCTIONAL DESCRIPTION

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before adjusting or

checking function on the tool.

Installing or removing battery cartridge

014963

CAUTION:

Always switch off the tool before installing or

•

removing of the battery cartridge.

Hold the tool and the battery cartridge firmly

•

when installing or removing battery cartridge.

Failure to hold the tool and the battery cartridge

firmly may cause them to slip off your hands and

result in damage to the tool and battery cartridge

and a personal injury.

To remove the battery cartridge, slide it from the tool

while sliding the button on the front of the cartridge.

To install the battery cartridge, align the tongue on the

battery cartridge with the groove in the housing and slip

it into place. Insert it all the way until it locks in place

with a little click. If you can see the red indicator on the

upper side of the button, it is not locked completely.

CAUTION:

Always install the battery cartridge fully until the

•

red indicator cannot be seen. If not, it may

accidentally fall out of the tool, causing injury to

you or someone around you.

Do not install the battery cartridge forcibly. If the

•

cartridge does not slide in easily, it is not being

inserted correctly.

Switch action

CAUTION:

Before inserting the battery cartridge into the tool,

•

always check to see that the switch trigger

actuates properly and returns to the "OFF"

position when released.

1. Red indicator

2. Button

3. Battery cartridge

015150

To start the tool, simply pull the switch trigger. Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

NOTE:

The tool automatically stops if you keep pulling the

•

switch trigger for about 360 seconds.

Electric brake

This tool is equipped with an electric brake. If the tool

consistently fails to quickly stop after the switch trigger is

released, have the tool serviced at a Makita service center.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the source of light

•

directly.

015151

014966

To turn on the lamp status, press the button

seconds. To turn off the lamp status, press the button

for few seconds again.

With the lamp status ON, pull the switch trigger to turn on

the lamp. To turn off, release it. The lamp goes out

approximately 10 seconds after releasing the switch trigger.

With the lamp status OFF, the lamp will not turn on even

if the trigger is pulled.

1. Switch trigger

1. Lamp

1. Button

for few