Makita 6228DWE Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bohrer Makita 6228DWE herunter. Makita 6228DWE 19 Seiten. 9.6 v i2 v 14.4 v
Auch für Makita 6228DWE: Gebrauchsanweisung (19 seiten), Gebrauchsanweisung (19 seiten), Gebrauchsanweisung (19 seiten)

Seite drucken

Spwdchange

To change the speed, first switch off the

tool and then slide the speed change lever

to the "11" side for high speed or

"I"

side

for low speed. Be sure that the speed

change lever is set to the correct position

before operation. Use the right speed for

your job.

Low

speed

High speed

Speed change

lever

CAUTION:

.Always set the speed change lever fully to the correct position. If you operate the tool

with the speed change lever positioned half-way between the

"I"

side and

"11"

side, the

tool may be damaged.

Do not use the speed change lever while the tool is running. The tool may be damaged.

Adjusting the fastening torque

The fastening torque can be adjusted in 17

steps by turning the adjusting ring so that

its graduations are aligned with the pointer

on the tool body. The fastening torque is

minimum when the number 1 is aligned

with the pointer, and maximum when the

marking is aligned with the pointer.

The clutch will slip at various torque levels

when set at the number 1 to 16. The clutch

is designed not to slip at the

marking.

Before actual operation, drive

trial screw

into your material or a piece of duplicate

material to determine which torque level is required for

particular application.

NOTE:

.Do not operate the tool with the adjusting ring set between the number

16 and the

marking. The tool may be damaged.