Gardena ErgoJet 2500 Betriebsanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Gebläse Gardena ErgoJet 2500 herunter. Gardena ErgoJet 2500 17 Seiten. Electric blower/vac
Auch für Gardena ErgoJet 2500: Betriebsanleitung (18 seiten), Betriebsanleitung (19 seiten), Betriebsanleitung (19 seiten), Betriebsanleitung (10 seiten), Betriebsanleitung (9 seiten), Benutzerhandbuch (8 seiten)

Connecting the unit:

Starting the unit:

Working positions:

WARNING! To avoid damage to the plug, the extension cable must

be inserted into the cable lock.

1. First make a loop with the extension cable

into the cable lock

2. Connect the unit's plug to the extension cable.

3. Connect the extension cable to a 230-V mains socket.

To start:

v Move the ON/OFF switch

The unit starts.

NOTE: For ErgoJet 3000 (EJ 3000) only: The motor speed can

be increased or decreased by using the variable speed control

CAUTION: To avoid causing damage to the unit, only use the

variable speed control in blow mode. DO NOT attempt to use the

variable speed control in vacuum mode. Lower speeds during

vacuum use could allow debris to build up, stall the motor and

cause unit failure.

To stop:

v Move the ON/OFF switch

The unit stops.

Blow mode

Use your unit as a blower for sweeping debris or grass clippings

from driveways, sidewalks, patios, etc. Also, for blowing grass

clippings, straw, or leaves into piles, or removing debris from

corners, around joints, or between bricks.

For ErgoJet 3000 (EJ 3000) only:

Use the variable speed control to increase or decrease the motor

speed during blower use.

Direct air flow by directing the blower tube down or to one side.

Always work away from solid objects such as walks, large stones,

vehicles, and fences.

Clean corners by starting in corners and moving outward. This will

help prevent an accumulation of debris which could fly into your

face. Be careful when working near plants. The force of the air

could damage tender plants.

and pull the extension cable tight.

to the ON position.

to the OFF position.

, thread the loop