A&E Systems WeatherPro Oasis Elite Diagnostisches Service-Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Diagnostisches Service-Handbuch für Zubehör A&E Systems WeatherPro Oasis Elite herunter. A&E Systems WeatherPro Oasis Elite 14 Seiten.

Seite drucken

FIG. 3.4

WeatherPro

Rocker Switch

SECTION 2 Wind Sensor

2.1 The wind sensor monitors the wind speed and

sends a signal to the control box if wind speeds

exceeds the preset setting. The correct position

of the winds sensor is critical. It shoud be within

3 feet of the right side top mounting bracket and

away from other objects. To check out the wind

sensor, extend the awning and place the wind

sensor switch in the ENABLE (ON) position. You

can create sufficient amount of wind by placing a

standard hair dryer approximately 6 inches away

from the wind sensor with the dryer set on HIGH

and NO HEAT. The awning should close auto-

matically.

Control Box

Wind Sensor Switch

WeatherPro

Remote

Switch

EXTEND

Green

Blue

RETRACT

Yellow

Brown

Wind Sensor Switch

ENABLE (ON)

DISABLE (OFF)

12 VDC

Supply

FIG. 2.1

Cable to Wind Sensor

(18 Foot Maximum)

T14 T15 T16 T17 T18

T10

T12 T13

T11

Green

Yellow

Brown

Black 12VDC -

SECTION 3 Control Box

3.1 Circuit Board

3.1.2 Check for 12.5 VDC (minimum) at T1 (red

3.1.3 Check for 12.5 VDC (minimum) on each

3.1.4 Check for voltage at the WeatherPro out-

T19 T20

Brown White

WeatherPro

Oasis Elite

Output

The control box is the heart of the system and

contains a fuse, rocker switch, wind sensor toggle

switch & circuit board.

The circuit board can be checked out by the pro-

cess of elimination. Make sure there is 12.5 VDC

going into the circuit board.

3.1.1 Disconnect all pig tails coming out of the

control box.

+) and T3 (black –) on circuit board.

leg of fuse. Place the negative lead of the

volt meter on T3 and check each leg of

the fuse with the positive lead. This should

read 12.5 VDC on each leg. Replace if

defective.

put pigtail (Red & Black wire). First, press

and hold the rocker switch in the extend

position. Place the negative lead of the

digital volt meter on the Black wire posi-

tion of the pigtail and the positive lead of

the volt meter on the Red wire position of

the pigtail. The meter should read (–)

negative 12.5 VDC (minimum). Do not

move the volt meter leads and press and

hold the rocker switch in the retract posi-

tion. The meter should read (+) positive

12.5 VDC (minimum).

Oasis Elite

Remote

Switch