A&I Products A-AH474 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Heizgerät A&I Products A-AH474 herunter. A&I Products A-AH474 2 Seiten.

Seite drucken

INSTALLATION INSTRUCTIONS:

1. This versatile heater may be mounted vertically. Typical locations include floor, wall or under

dash.

2. Route the heater hose to the engine compartment, using grommets through the fire wall, cut the

existing hose, add and clamp the Y splicer then run the new hose and clamp to the heater.

Avoid any sharp bends which may kink the hose and restrict proper flow. Run Y splicer with the

coolant flow. (See splicer diagram.)

3. Route power supply wire from fuse block to rocker switch, including the inline 7.5A amp fuse.

And finally, ground the heater case to the chassis of the vehicle. We recommend all electrical

connections are terminated or soldered and taped. (See the connection diagram below.)

WIRE CONNECTION DIAGRAM:

GROUND TO

CHASSIS

RED (LOW)

ORANGE

(HIGH)

Northern Factory Sales warranties its Heaters to be free from all defects in manufacturing and

workmanship for one year from the date of installation.

Any Heater claimed defective under this limited warranty should be forwarded to Northern Factory

Sales, transportation charges prepaid, for inspection and warranty determination.

Northern Factory Sales will not be responsible for heaters damaged from misuse or neglect. Any

expense associated with a warranty replacement, including but not limited to installation and

transportation charges, are not covered under this warranty. This warranty provides for product

replacement only. Any attempt at local repairs automatically voids this limited warranty.

OMAH474

MANUAL - PLEASE READ!

Operator Manual

SWITCH

7.5A FUSE

www.aiproducts.com

SPLICER DIAGRAM:

FROM AUX

HEATER

OUTLET

POWER

SOURCE

RETURN SIDE

NOTE: The low speed terminal is located behind the

high position due to internal switching.

A&I Products

TO AUX

HEATER

EXISTING

INLET

HEATER

HOSE

HOT SIDE