Alinco DJ-191 Kurzreferenz - Seite 2

Blättern Sie online oder laden Sie pdf Kurzreferenz für Sende- und Empfangsgerät Alinco DJ-191 herunter. Alinco DJ-191 3 Seiten. Cert communications team procedures
Auch für Alinco DJ-191: Gebrauchsanweisung (18 seiten), Gebrauchsanweisung (18 seiten), Kurzreferenz (4 seiten)

Seite drucken

CERT Communications Team Procedures

Alinco DJ-191 QUICK REFERENCE

Revised 08/18/2000

To Receive and Transmit on a Frequency Not Programmed

Using Simplex

1. If a M or C is displayed, press the A key (also labeled V/M for VFO/Memory).

–

2. If a

is displayed Press and hold the FUNCTION key (the top-most key

on the left side of the radio, labeled F) and press the 2 key repeatedly until the

–

disappears. Release the FUNCTION key.

3. Key in all six digits of the desired frequency using the keypad. (NOTE: The last

digit may be rounded up or down to the nearest frequency step. To change the

frequency step, see the manual for the radio.) You may also change the

frequency by rotating the dial on the top of the radio.

4. Listen. If the frequency is not being used, press the PUSH-TO-TALK button.

The PUSH-TO-TALK button is the largest button in the center of the left side

of the radio. It is labeled PTT. Take a breath and speak slowly and distinctly

across the microphone. The microphone is located in the lower-right corner of

the radio.

Using a Repeater

1. Have the following information about the repeater available:

a) Output frequency

b) If positive or negative offset is used

c) If a tone (PL) is required, and if so, the tone frequency.

2. If a M or C is displayed, press the A key (also labeled V/M for VFO/Memory).

3. Key in all six digits of the repeater output frequency using the keypad. (NOTE:

The last digit may be rounded up or down to the nearest frequency step. To

change the frequency step, see the manual for the radio.)

4. Press and hold the FUNCTION key (the top-most key on the left side of the

radio, labeled F). Press the 2 key repeatedly until either

–

for negative offset, appears. (The 2 key is also labeled SHIFT, another name

for offset.)

5. Release the FUNCTION key.

CERT Comm, Fremont, CA.

for positive offset or