Garmin Zumo XT Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für GPS Garmin Zumo XT herunter. Garmin Zumo XT 49 Seiten.
Auch für Garmin Zumo XT: Schnellstart-Handbuch (8 seiten), Installationsanleitung Handbuch (46 seiten)
Seite drucken
Automobile mode
Motorcycle mode
Off-road mode
Choosing a Transportation Mode
Select the transportation mode icon on the status bar.
Using the Large Button Keyboard
You can enable additional keyboard languages or layouts in the
language and keyboard settings .
• Select
or
to view more characters.
• Select
to switch to other keyboard languages and layouts.
Installation
Mounting Your Device in a Motorcycle
Powered Motorcycle Mount
Garmin
strongly recommends having an experienced installer
®
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device must be mounted in a suitable and secure location
on your motorcycle, based on available power sources and safe
cable routing. No fuse is required.
Motorcycle mount
10 to 30 Vdc system power (red)
System ground (black)
NOTE: Additional parts are included with the device to provide
more installation and wiring options. Contact an experienced
installer for more information about using these parts with your
motorcycle.
Crimp Style Ring Terminal: Connects the wiring harness
directly to the battery terminal.
Crimp Style Butt Splice Connector: Connects the wiring
harness to an existing wiring installation or extends the wiring
harness length.
Cable Tie: Secures cables to the motorcycle frame.
Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt
around the handlebar
ends through the handlebar base
2
WARNING
, and thread the
.
2
Tighten the nuts to secure the base.
NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket
.
NOTE: Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Power Cables to the Motorcycle Mount
1
Thread the power cable connector
in the motorcycle mount.
2
Pull the cable back until it is snug.
3
Screw the black screw
hold the cable in place.
through the handlebar base, spacers
through the opening
into the back of the mount
to
Installation