Garmin StreetPilot 7500 Kurzreferenz-Handbuch
Blättern Sie online oder laden Sie pdf Kurzreferenz-Handbuch für Auto-Navigationssystem Garmin StreetPilot 7500 herunter. Garmin StreetPilot 7500 2 Seiten. Declaration of conformity
Auch für Garmin StreetPilot 7500: Kurzreferenz-Handbuch (2 seiten), Benutzerhandbuch (26 seiten), Konformitätserklärung (1 seiten), Spezifikationen (2 seiten)
Seite drucken
Getting Ready
Congratulations on purchasing a StreetPilot 7200/7500! Follow the mounting and setup steps in this guide to get started. See the back
of this sheet to start using your StreetPilot. For more information, see the owner's manual that came in the box.
What's in the Box
Remove the following items from the box. You will need these items to mount the StreetPilot and get started.
Mounting Base on
7200/7500 Unit
Mounting Plate
© Copyright 2006 Garmin Ltd. or its subsidiaries
May 2006
➊
Attach the mounting plate to your dashboard.
1. Clean the area where you want to place the mount with
rubbing alcohol. Dry with a clean, dry cloth.
2. Remove the liner from the bottom of the mounting plate.
3. Place the mounting plate in the selected location.
4. Bend the edges of the mounting plate to fit the surface.
➋
Attach the mounting cradle to the StreetPilot.
1. Place the two tabs on the cradle into the two grooves on the top of the StreetPilot. (A)
2. Swing the cradle forward so that the StreetPilot is fully seated in the cradle. (B)
3. Slide the cradle's locking lever to the right (locked).
➌
Slide the mounting cradle into the base on the mounting plate.
1. Slide the bottom of the mounting cradle into the mounting base.
2. Slide the base's locking lever to the right (locked).
3. Plug the power cable into a 12-Volt receptacle in your vehicle.
4. Route the cable so it does not interfere with vehicle operation.
Warning: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the StreetPilot 7200/7500 installed to place and
secure the device so it does not interfere with the vehicle operating controls and safety devices, obstruct the driver's view of driving conditions,
or cause personal injury in the event of an accident.
Mounting Cradle with
Power Cable
190-00455-01 Rev. B
Mounting
cradle
A
StreetPilot
Attaching the Cradle to the StreetPilot
Locking lever
Sliding the Mount in the Base
StreetPilot 7200/7500
portable car navigation
IN
OUT
ZOOM
MENU
MAP
BACK
SPEAK
PAGE
VOL
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
PQRS
TUV
WXYZ
7
8
9
0
Remote
Control
Printed in Taiwan
➍
Configure your StreetPilot
If necessary, turn the key in the ignition to apply power to the StreetPilot. Follow the screen prompts to set up your
StreetPilot:
➊
Select a language. Touch Next.
B
Puck
➍
Select an option. Touch Next.
Power button
Quick Reference Guide
➋
➌
Touch a time zone. Touch Next.
Select an option. Touch Next.
➎
➏
Wait a few minutes.
Touch Done.