AlkaWay AlkaLina alkaline Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Filtration Systems AlkaWay AlkaLina alkaline herunter. AlkaWay AlkaLina alkaline 4 Seiten. Reverse osmosis water filter

Seite drucken

How To Cut Tubing forJohn Guest Fittings

1. Use a very sharp knife or razor blade to get a clean right angle cut.

2. Check to make sure you have a nice clean & even end.

A Friendly Hint:

If it looks too hard, maybe it is. Sometimes your original system has been

installed in a way that it takes up most of the room undersink. Find a handy

friend or a good plumber familiar with Reverse Osmosis systems.

What You've Received:

1. AlkaLina Cartridge with Quickfit connectors top and bottom

2. H2 Diffuser with Quickfit connectors top and bottom.

3. Clips to mount filters

4. 1/4" Hose.

5. pH Reagent

6. Spanner

Turn off your mains water at the tap feeding the RO.

This will be under the sink on your cold water feed

pipe. (See RED '1' on diagram). Turn ON your benchtop

faucet.

Determine where you want to install the two filters.

Make locating marks and mount the clamps for the

filters.

Locate the hose from the RO to the faucet. To locate

this go to the underside of the faucet and trace the

hose back. Cut it close to the RO (or remove it from the

RO)(See RED '2' on diagram)

Mount the filters in the clamps

Attach the faucet hose to the outlet point of the H2

filter. (See RED '3' on diagram)

Cut sufficient hose to go from the AlkaLina to the H2

cartridge inlet. Push hoses in hard, then push again

to secure properly.. That's all you need to to make it

watertight. (See RED '4' on diagram)

Cut sufficient hose to attach the RO to the inlet of the

AlkaLina. (See RED '5' on diagram)

Turn on your cold water tap to resupply water to your

RO. Check if there are any leaks in your connections.

If so, turn off the cold water supply, turn on the faucet

to relieve pressure. Remove the leaking hose, recut hose end

square as shown above, and re-insert.

Turn on your cold water again and allow the water to

flow through your benchtop faucet. Let it run for 5-10

minutes then turn off.

YOUR ALKALINA MAY 'SPUTTER' FOR SOME

TIME WHEN TURNED ON. THIS DEMONSTRATES

THAT THE HYDROGEN ENRICHED WATER IS

BEING CREATED. TRY TO DRINK THIS

'FIRST SHOT'.

REMEMBER TO REGISTER YOUR

ALKALINA FOR WARRANTY.

H2 DIFFUSER

ALKALINA