Garmin GPSMAP 3005C Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für GPS-System für die Schifffahrt Garmin GPSMAP 3005C herunter. Garmin GPSMAP 3005C 10 Seiten. Declaration of conformity
Auch für Garmin GPSMAP 3005C: Kurzreferenz-Handbuch (2 seiten), Vorlage Handbuch (1 seiten), Kurzreferenz (2 seiten), Installationsanleitung Handbuch (17 seiten), Konformitätserklärung (1 seiten)

4. Using the jigsaw, cut the mounting surface along the inside of the solid line indicated on the flush-mount template. Use a file and sandpaper

to refine the size of the hole. Be very careful when cutting this hole. There is only a small amount of clearance between the case and

the mounting holes.

5. Install the four mounting studs into the chartplotter by screwing the shorter, threaded section into the back of the chartplotter. Use the

(2 mm) Allen wrench to tighten the mounting studs until they stop. Do not overtighten - you may damage the mounting stud or the

mounting holes. The studs are coated with a reusable thread-locking patch applied at the factory.

6. Place the chartplotter in the hole and make sure that the mounting studs line up with the pilot holes on the flush-mount template after cutting,

sanding, and filing the hole. If they do not, mark the locations where the studs will feed through the mounting surface.

7. Using the center punch, indent the center of each of the 4 mm mounting-hole locations.

8. Using a

in. (3 mm) drill bit, drill the four mounting holes.

9. Place the chartplotter into the cutout. The four mounting studs should feed through the four mounting holes drilled in Step 8.

10. P lace the flat washers over the mounting studs, then thread the hex nuts onto the mounting studs. Tighten all four hex nuts evenly until the

chartplotter is snug against the mounting surface.

To install the GPS 17x antenna, select a suitable location, mount the antenna, and connect the antenna to power and to your GPSMAP 3000

series chartplotter.

Mount the GPS 17x Antenna

You can surface mount the GPS 17x antenna, attach it to a standard 1 in. OD pipe-threaded-pole marine mount (14 threads-per-inch—not

included), or even install the antenna under fiberglass.

Select a suitable location for the GPS 17x antenna on your boat. To ensure the best reception, mount the GPS 17x antenna in a location that has

a clear, unobstructed view of the sky in all directions.

•

Avoid mounting the GPS 17x antenna where it is shaded by the superstructure of the boat, a radome antenna, or mast.

•

On a sailboat, avoid mounting the GPS 17x antenna high on the mast, to prevent inaccurate speed readings caused by excessive heeling.

GPSMAP 3000 Series Installation Instructions

Threaded

Washer Hex nuts

mounting stud

Installing the GPS Antenna

Mounting surface

in.