Garmin GPSMAP 4208 - Marine GPS Receiver Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für GPS-System für die Schifffahrt Garmin GPSMAP 4208 - Marine GPS Receiver herunter. Garmin GPSMAP 4208 - Marine GPS Receiver 19 Seiten. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Auch für Garmin GPSMAP 4208 - Marine GPS Receiver: Wichtige Sicherheitsinformationen (4 seiten), Wichtige Informationen (2 seiten), Benutzerhandbuch (2 seiten), Technische Referenz (30 seiten), Installationsanleitung Handbuch (25 seiten), Installationsanleitung Handbuch (25 seiten), Kurzreferenz-Handbuch (2 seiten), Konformitätserklärung (1 seiten), Zusatzhandbuch (24 seiten)

To flush mount the unit:

1. The flush mount template is included in the product box. Trim the template and ensure it will fit in the location you want to flush mount the

unit.

NoTE: Make sure the surface on which you mount the unit has at least 7" (17.75 cm) of open space behind it to fit the unit and the connected

wires.

NoTE: Make sure to leave approximately

NoTE: Mount a 4008/4208/5008/5208 unit 31

interference.

2. The flush mount template has adhesive on the back. Remove the protective liner and apply the template to the location you want to mount

the unit.

3. Using the center punch, indent the center of each of the 4 mm mounting hole locations.

4. Using a 4 mm drill bit, drill the four mounting holes.

5. Using a

" (6 mm) drill bit, drill one or more of the four pilot holes inside the corner of the template to begin cutting the mounting surface.

6. Using the jig saw, cut the mounting surface along the inside of the solid line indicated on the flush mount template. Use a file and

sandpaper to refine the size of the hole. Be very careful when cutting this hole. There is only a small amount of clearance between

the case and the mounting holes.

7. Install the four mounting studs into the unit by screwing the shorter, threaded section into the back of the unit. Use the

wrench to tighten the mounting studs until they stop. Do not overtighten - you may damage the mounting stud or the mounting holes.

The studs are coated with a reusable thread-locking patch applied at the factory.

8. Place the unit into the cut-out. The four mounting studs should feed through the 4 mounting holes drilled in step 3.

9. Place the flat washers, then the lock washers over the mounting studs. Thread the hex nuts onto the mounting studs. Tighten all four hex

nuts evenly until the unit is snug against the mounting surface.

GPSMAP 4000/5000 Series Installation Instructions

" (13 mm) of space on the right side of the unit to access the SD card door.

" (80 cm), and a 4012/4212/5012/5212 unit 39

Flush Mounting the GPSMAP 4000/5000 Series Unit

" (1 m) from a magnetic compass to avoid

" (2 mm) Allen