Garmin TR-1 Gold Montageanleitung - Seite 5

Blättern Sie online oder laden Sie pdf Montageanleitung für GPS-System für die Schifffahrt Garmin TR-1 Gold herunter. Garmin TR-1 Gold 7 Seiten. Throttle actuator
Auch für Garmin TR-1 Gold: Benutzerhandbuch (38 seiten), Grundlegendes Betriebshandbuch (9 seiten), Kurzreferenz (2 seiten), Einbauanleitung (4 seiten), Owner Handheld Kurzreferenz (2 seiten)

Figure 8

Step Two:

Slide the small end of the Stern Pivot Pin (item 5) through

the holes at the rear of both flanges. Secure the Pivot Pin

in place by inserting a Medium Hair Pin Cotter (item 13)

through the hole below the bottom flange. See Figure 9.

Figure 10

Page 5

Put a little thread locker on the second 8MM

(item 8) bolt and install it through the other Lock

Washer (item 9), the sandwich of the Cylinder

Mounting Channel (item 6) and Doubler Plates

(item 7) created at Fig. 6, the upper Short Standoff

(item 2), and into the upper motor vibration

isolation mount. Keep the Channel perpendicular

to the motor down shaft and tighten the bolt.

Step Three:

Install the Rod Eye Bracket (item 4) by putting

the lower channel flange against the top of the

motor grease fitting boss (as shown in Fig. 10),

slide in the "U" Bolt (item 10), put on the Lock

Washers (item 11), a little thread lock, and screw

on and tighten the nuts.

Figure 9