Garmin Gladiator TR-1 Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schiffsausrüstung Garmin Gladiator TR-1 herunter. Garmin Gladiator TR-1 36 Seiten. Garmin tr-1 marine autopilot: user guide
Auch für Garmin Gladiator TR-1: Installations- und Benutzerhandbuch (4 seiten), Benutzerhandbuch (13 seiten)

Seite drucken

Fig 3

Heading Hold

Boat Path

2. Select the Setup Code you want to use by pressing and releasing the button labeled 8 or 9 until the

appropriate LED is lit. (See the Codes and Setup Choices on the table below.)

3. Increase an adjustable parameter one step by each press of the [UP Arrow] button. When the parameter is

adjusted to its maximum value, the [Up Arrow] LED will light. The parameter is adjusted and is in use by the

autopilot immediately.

4. Decrease an adjustable parameter one step by each press of the [Down Arrow] button. When the

parameter is adjusted to its minimum value, the [Down Arrow] LED will light. The parameter is adjusted and

is in use by the autopilot immediately.

5. To save the changes into permanent memory and make the selected function into a

startup default: Press and release the [Setup] button (the [Setup] LED should be lit),

and then press and hold the [Select Load] button. While holding down the [Select Load]

button, press and release the [Deckmount] On/Off button quickly, then release the GPS

[Select Load] button.

Description

Zigzag Amplitude (Degree of turn)

Zigzag Period (Length)

Change Heading Using Zigzags

If you program the [Plus (+)] button for Zigzags (Fig 3) ,and you then press

the [Plus(+)] button the pilot will begin to zigzag about the heading you

were on when you pressed the button. The zigzag angle and period are both

programmable. An example zigzag path is shown in the fi gure below. When the

system is doing zigzags, it will return to heading hold if either the [Left Arrow],

[Right Arrow] or [Plus(+)] buttons are pressed.

To engage Zigzags:

1) Press and hold the [Setup] button.

2) Press and light up the [number 2, Zigzag] LED on the handheld.

3) Release the [Setup] Button.

To start the zigzags, press and release the [Zigzag/Plus (+)] button on the

handheld, the autopilot will start the zig-zags.

Factory default sets the zig-zags at 30 degrees per zig-zag and the cycle

time is 3 minutes. If you wish to change those settings refer to the setup

codes below and refer to [Code 8] for the Amplitude (Degree of turn) 10

choices; 5 to 50 degrees by 5's. [Code 9] The Zig-zag period (Length/Time)

has 20 choices from 1/2 to 10 minutes by 1/2's.

To change the setup options for zigzags:

You must be in [Auto] or [STBY] mode before selection process can start

1. Press and release the [Setup] Button. The [Setup] LED will illuminate to

indicate the system is ready to take setup commands (button pushes).

Code

10 choices/ 5 to 50 Degrees by 5's

20 choices 1/2 to 10 minutes by 1/2's

Setup Options (Parameters)

Factory Settings

30 degrees

1.5 minutes